PHASE STABILITY AND SEMICONDUCTING BEHAVIOUR OF LOW ACTIVATION AUSTENITIC MN-CR STEELS

نویسندگان

  • M Asadi Asadabad Materials Research School, Nuclear Science and Technology Research Institute, Isfahan, Iran.
چکیده مقاله:

Four compositions of austenitic Mn-Cr steels have been developed successfully for in-vessel component materials in power plant industry. The phase stability of these Mn-Cr steels was studied by and X-ray diffraction (XRD) patterns. XRD patterns have shown that the matrix of these Mn-Cr steels is a single γ-phase structure. The potentiodynamic polarisation curves suggested that these fabricated Mn-Cr steels showed passive behaviour in 0.1M H2SO 4solution. Therefore, semiconducting behaviour of passive film formed on these fabricated Mn-Cr steels in 0.1M H2SO 4 solution was evaluated by Mott–Schottky analysis. This analysis revealed that passive films behave as n-type and p-type semiconductors. Based on the Mott–Schottky analysis, it was also shown that donor and acceptor densities are in the order of 1021 cm -3 and are comparable for other austenitic stainless steels in acidic environments

برای دانلود باید عضویت طلایی داشته باشید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Evaluation of corrosion behaviour on Mn-Cr austenitic steels using 0.1 M HCl solution

One of the attractive low activation steels is the austenitic Mn-Cr steel from the view point of waste disposal because of few long-lived nuclides. In this paper, three types of Mn-Cr austenitic steels were fabricated by vacuum induction furnace. Then plates with 10 mm thickness were fabricated by hot-rolling. The physical metallurgy of these steels was studied by the corrected Schaeffler diagr...

متن کامل

corrosion behaviour investigation of the four cr-mn-(ni-free) austenitic steels in 0.1 m h2so4 solution

in this study, the four cr-mn-(ni-free) austenitic steels were fabricated by vacuum induction furnace. then plates with 10 mm thickness were fabricated by hot-rolling. corrosion behaviour of the four cr-mn steels in 0.1 m h2so4 solution was investigated using by open-circuit potential, potentiodynamic polarization, and electrochemical impedance spectroscopy (eis). the results indicated that the...

متن کامل

Low-Temperature Carburization of Austenitic Stainless Steels

LOW-TEMPERATURE CARBURIZATION is a gaseous carburization process performed at atmospheric pressure, at temperatures where the kinetics of substitutional diffusion are very slow. Low-temperature carburization hardens the surface of austenitic stainless steels through the diffusion of interstitial carbon, without the formation of carbides. The surface must be activated, by modification and remova...

متن کامل

Effect or Inoculation on Microstructure and Properties of Low C-Mn and Low Alloy Steels

Effect of the addition of various inoculants on the morphology and mechanical properties of low C-Mn and low alloy steel samples is studied by thermal and mechanical processing of the samples after solidification. According to the results obtained from metallographic studies with the electron microscope and microanalysis with x-rays, the distribution of inoculating agents in the steel matrix is...

متن کامل

Transient liquid phase bonding of AISI 304L stainless steels with the austenitic and martensitic microstructures

In the present study, the effect of time and base metal microstructure on the Transient Liquid Phase (TLP) bonding of 304L stainless steel was studied. TLP was performed at 1050 0C for 5 and 60 minutes on the coarse grain austenitic and martensitic microstructure using BNi-2 interlayer. To prepare martensitic microstructure, as-received 304L was rolled at -15 0C up to 80% rolling reduction. TEM...

متن کامل

A Critical Assessment of First Principles Inputs for Modeling RIS in Austenitic Fe-Cr-Ni Steels

Radiation induced segregation (RIS) in austenitic Fe-Cr-Ni steels is a widely studied but incompletely understood process important for reactor components. Experimental studies have shown that Cr depletes strongly at grain boundaries, giving rise to corrosion resistance issues. Various research throughout the years has produced models that make specific assumptions about the dominant mechanisms...

متن کامل

منابع من

با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

ذخیره در منابع من قبلا به منابع من ذحیره شده

{@ msg_add @}


عنوان ژورنال

دوره 11  شماره 4

صفحات  20- 27

تاریخ انتشار 2014-12

با دنبال کردن یک ژورنال هنگامی که شماره جدید این ژورنال منتشر می شود به شما از طریق ایمیل اطلاع داده می شود.

کلمات کلیدی

میزبانی شده توسط پلتفرم ابری doprax.com

copyright © 2015-2023