Mitigation Transformer Inrush Current Using Modified Transient Current Limiter

نویسندگان

  • D. Azizian Department of Electrical Engineering, Abhar Branch, Islamic Azad University, Abhar, Iran
  • M. Bigdeli Department of Electrical Engineering, Zanjan Branch, Islamic Azad University, Zanjan, Iran
  • M. Ganji Department of Electrical Engineering, Zanjan Branch, Islamic Azad University, Zanjan, Iran
چکیده مقاله:

This study presents a modified transient current limiter (MTCL) for mitigation the inrush current of transformers. The MTCL is based on conventional transient current limiter (TCL), which, its configuration is modified to overcome the TCL drawbacks of operation. The proposed MTCL offers lower power losses and voltage/current THD during normal operation mode. It needs only one limiting reactor instead of two limiting reactors, which results in cost saving. The theoretical analysis of the MTCL for suppressing the inrush current has been presented and the performance was tested by PSCAD/EMTDC simulation anda experimental prototype. Both simulation and experimental results showed that the MTCL is effective for suppressing the transformer inrush current. Also, the capability of the MTCL for suppressing the transformer inrush current was compared with the conventional TCL.

برای دانلود باید عضویت طلایی داشته باشید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Mitigation of Inrush Current of Transformer using Voltage Sag Compensator

In the power system voltage sag become the important issue for industries. According to the survey 92% of the interruptions at industrial installations are voltage sag related. In various companies voltage sag may affect many manufactures and introduce sufficient losses in the power system. The voltage sag compensator, based on a transformer coupled series connected voltage source inverter, is ...

متن کامل

Detection of inrush current in distribution transformer using wavelet transform

Inrush currents in transformers are non-sinusoidal, high magnitude currents generated due to flux saturation in the core during energization. For protection purpose, in this paper an efficient method for detection of inrush current in distribution transformer based on wavelet transform is presented. Using this method inrush current can be discriminated from the other switching transients such a...

متن کامل

Power Transformer Modeling for Inrush Current Calculation

The paper documents a new transformer model in ATPDraw called XFMR. This model handles 3-phase transformers with two or three windings. Autotransformers and all Wye and Delta couplings are supported. The model includes an inverse inductance matrix for the leakage description, optional frequency dependent winding resistance, capacitive coupling, and a topologically correct core model (3and 5-leg...

متن کامل

Transformer Inrush Current and Related Challenges

Energizing of large power transformers is considered a critical event in the operation of an electric power system. When a transformer is energized by the grid or utility, it takes very high value current known as inrush current, the typical value of this current could be ten times. This inrush causes many problems like mechanical stress on transformer & harmonics injection to generator winding...

متن کامل

Transformer inrush current mitigation using controlled switching and magnetic flux shunts

The inrush current is a transient current that results from a sudden change in the exciting voltage across a transformer’s windings. It may cause inadvertent operation of the protective relay system and necessitate strengthening of the transformer’s mechanical structure. Many methods were reported in the literatures for reduction and mitigation of transformer inrush currents. This paper represe...

متن کامل

Investigation and Mitigation of Transformer Inrush Current during Black Start of an Independent Power Producer Plant

The energizing of large power transformers has long been considered a critical event in the operation of an electric power system. When a transformer is energized by the utility, a typical inrush current could be as high as ten times its rated current. This could cause many problems from mechanical stress on transformer windings to harmonics injection, and system protection malfunction. There h...

متن کامل

منابع من

با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

ذخیره در منابع من قبلا به منابع من ذحیره شده

{@ msg_add @}


عنوان ژورنال

دوره 32  شماره 5

صفحات  701- 709

تاریخ انتشار 2019-05-01

با دنبال کردن یک ژورنال هنگامی که شماره جدید این ژورنال منتشر می شود به شما از طریق ایمیل اطلاع داده می شود.

میزبانی شده توسط پلتفرم ابری doprax.com

copyright © 2015-2023