Mini two-shaft gas turbine exergy analysis with a proposal to decrease exergy destruction

نویسندگان

  • Mojtaba Haratian Department of Mechanical Engineering, Khomeinishahr Branch, Islamic Azad University, Isfahan, Iran
چکیده مقاله:

In this case study, exergy analysis is applied to a mini two-shaft gas turbine which is located in Islamic Azad University Khomeini Shahr Branch`s Thermodynamics laboratory and a proposal presented to make exergy destruction less using a Heat Recovery Water Heater (HRWH). Calculations were done for N2=20000 (rpm) constant and various N1 and after that for N1=60000 (rpm) constant and various N2. Results revealed that the highest exergy destruction rate occurs in combustion chamber in all conditions and a huge part of exergy destruction through the turbine exhaust. Increase in N1 leads to increases in all component exergy destruction rates. On the other hand, power turbine is the only component which is affected by changes in N2 and the exergy destruction rate increases with increase in N2. Moreover, exergy gained rate within HRWH increased with increase in N1 and is almost constant with changes in N2. In the same vein, exergetic efficiency of HRWH and exergy gained rate within HRWH are increased with decrease in water outlet temperature of HRWH.

برای دانلود باید عضویت طلایی داشته باشید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Exergy Analysis of Overspray Process in Gas Turbine Systems

Gas turbine power can be augmented by overspray process which consists of inlet fogging and wet compression. In this study exergy analysis of the overspray process in gas turbine system is carried out with a non-equilibrium analytical modeling based on droplet evaporation and the second law of thermodynamics. This work focuses on the effects of system parameters such as pressure ratio, water in...

متن کامل

Thermo-Exergy Optimization of Gas Turbine Cycle with Two Different Regenerator Designs

Abstract—A thermo-exergy optimization of a gas turbine cycle with two different regenerator designs is established. A comparison was made between the performance of the two regenerators and their roles in improving the cycle efficiencies. The effect of operational parameters (the pressure ratio of the compressor, the ambient temperature, excess of air, geometric parameters of the regenerators, ...

متن کامل

Transient Exergy Destruction Analysis of a Vapor Compression System

Through online optimization and control, vapor compression systems (VCSs) can effectively respond to disturbances, such as weather or varying loads that cannot be accounted for at the design stage, while simultaneously maximizing system efficiency. However, to do so requires a mathematical characterization of efficiency for the VCS. In particular, we would like to maximize the exergetic efficie...

متن کامل

Exergy, Ecology and Democracy - Concepts of a Vital Society or A Proposal for An Exergy Tax

The vitality of the society is strongly depending on the management of physical, environmental and human resources. The dilemma of the modern society can be stated: misuse of physical resources from poor understanding of concepts such as exergy, misuse of nature from ignorance of ecology and misuse of people or human intelligence from lack of democracy. Exergy is a well-established concept in e...

متن کامل

Olexan: A Tool for Online Exergy Analysis

Exergy analysis is important and has been widely used to evaluate the thermodynamic efficiency of a variety of processes. Therefore, there is a need to develop a tool for monitoring exergy of a process in real-time and for studying the effects of various feed, equipment, process and environmental changes. The ultimate aim of this work is to develop a tool to enable dynamic and online exergy ana...

متن کامل

Utility of thermodynamic (exergy-exergy) analysis in cryogenic systems for liquefaction of gases: A Review

The exergy efficiency depend upon mainly upon the inlet condition of the system because inlet condition best suit for a particular type of the system except to increase the whole system efficiency stresses are done on particular parts of system and research are done on that systems. It was observed that that every part of system has its own and equal importance because ones effect on another wh...

متن کامل

منابع من

با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

ذخیره در منابع من قبلا به منابع من ذحیره شده

{@ msg_add @}


عنوان ژورنال

دوره 6  شماره 2

صفحات  131- 141

تاریخ انتشار 2018-06-01

با دنبال کردن یک ژورنال هنگامی که شماره جدید این ژورنال منتشر می شود به شما از طریق ایمیل اطلاع داده می شود.

میزبانی شده توسط پلتفرم ابری doprax.com

copyright © 2015-2023