Local Heat Transfer Coefficients in a Rectangular Duct with Plate Blockages of Variable Stream Wise Spacing

نویسندگان

  • I. Mirzaee Mechanical Engineering, Isfahan University of Technology
  • Majid Molki Mechanical Engineering, Southern Illinois University
چکیده مقاله:

An experimental investigation is conducted to determine the effect of repeated-plate blockages of variable streamwise spacing on heat transfer characteristics of turbulent flow in rectangular ducts. The plates are attached to the upper and lower walls in a staggered arrangement. The experiments are carried out by mass transfer and the analogy between heat and mass transfer provides the necessary link between the two processes. The study encompasses both the developing and the periodically fullydeveloped portions of the duct, and the axial distribution of the local transfer coefficients are discussed. The principal variables of the problem are Reynolds number Re, plate height h. and plate streamwise spacing L. The range of Re, h/H (H= duct height), and L/H considered in this study are 3000-50000, 0-0.5, and 1-7. The measurements extended downstream to about 13 duct hydraulic diameter.

برای دانلود باید عضویت طلایی داشته باشید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Average Heat Transfer Coefficient in Rectangular Ducts with Baffle Blockages

An experimental investigation was conducted to study the average and the fully-developed heat (mass) transfer coefficients in a rectangular smooth duct and a duct with repeated-baffle blockages. The focus of attention in this work is the conventional correlation Nu / Nufd 1 + C / ( X / D ) for the average heat transfer coefficient. It was shown that for relatively short ducts, the coefficient C...

متن کامل

Analysis of Fluid Dynamics and Heat Transfer in a Rectangular Duct with Staggered Baffles

This computational fluid dynamic analysis attempts to simulate the incompressible steady fluid flow and heat transfer in a solar air channel with wall-mounted baffles. Two ꞌSꞌ-shaped baffles, having different orientations, i.e., ꞌSꞌ-upstream and ꞌSꞌ-downstream, were inserted into the channel and fixed to the top and bottom walls of the channel in a periodically staggered manner to develop vorti...

متن کامل

Mass „Heat... Transfer Downstream of Blockages With Round and Elongated Holes in a Rectangular Channel

Turbulent forced convective mass (heat) transfer downstream of blockages with round and elongated holes in a rectangular channel was studied. The blockages and the channel had the same 12:1 (width-to-height ratio) cross section, and a distance equal to twice the channel height separated consecutive blockages. The diameter of the holes was either 0.5 or 0.75 of the height of the channel. Naphtha...

متن کامل

Fluid flow and heat transfer characteristics in a curved rectangular duct using Al2O3-water nanofluid

In the present research, the laminar forced convective heat transfer and fluid flow characteristics for Al2O3-water nanofluid flowing in different bend (i.e., 180o and 90o) pipes have been investigated numerically in a three-dimensional computational domain using the finite volume technique. The effects of different pertinent parameters, such as the Reynolds number of the duct, volume fraction ...

متن کامل

Fluid Flow and Heat Transfer of Nanofluids over a Flat Plate with Conjugate Heat Transfer

The falling and settling of solid particles in gases and liquids is a natural phenomenon happens in many industrial processes. This phenomenon has altered pure forced convection to a combination of heat conduction and heat convection in a flow over a plate. In this paper, the coupling of conduction (inside the plate) and forced convection of a non-homogeneous nanofluid flow (over a flat plate) ...

متن کامل

numerical simulation of viscoelastic developing flow and heat transfer in a rectangular duct

this paper presents a numerical simulation of developing flow and heat transfer of a viscoelastic fluid in a rectangular duct. in fully developed flow of a viscoelastic fluid in a non-circular duct, secondary flows normal to the flow direction are expected to enhance the rate of heat and mass transfer. on the other hand, properties such as viscosity, thermal conductivity, specific heat and rela...

متن کامل

منابع من

با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

ذخیره در منابع من قبلا به منابع من ذحیره شده

{@ msg_add @}


عنوان ژورنال

دوره 7  شماره 1

صفحات  33- 40

تاریخ انتشار 1994-02-01

با دنبال کردن یک ژورنال هنگامی که شماره جدید این ژورنال منتشر می شود به شما از طریق ایمیل اطلاع داده می شود.

میزبانی شده توسط پلتفرم ابری doprax.com

copyright © 2015-2023