Ivestigation of Entropy Generation in 3-D Laminar Forced Convection Flow over a Backward Facing Step with Bleeding

نویسندگان

چکیده مقاله:

A numerical investigation of entropy generation in laminar forced convection of gas flow over a backward facing step in a horizontal duct under bleeding condition is presented. For calculation of entropy generation from the second law of thermodynamics in a forced convection flow, the velocity and temperature distributions are primary needed. For this purpose, the three-dimensional Cartesian coordinate system is used to solve the Navier-Stokes and energy equations by the computational fluid dynamic techniques. Discretized forms of these equations are obtained by the finite volume method and solved using the SIMPLE algorithm. The numerical results are presented graphically and the effects of bleeding coefficient on the distributions of entropy generation and Nusselt numbers along the duct’s wall and also on total entropy generation are presented. The numerical results can be used in design of such thermal system with high performance. Comparison of numerical results with the available data published in open literature shows a good consistency.

برای دانلود باید عضویت طلایی داشته باشید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Three Dimensional Laminar Convection Flow of Radiating Gas over a Backward Facing Step in a Duct

In this study, three-dimensional simulations are presented for laminar forced convection flow of a radiating gas over a backward-facing step in rectangular duct. The fluid is treated as a gray, absorbing, emitting and scattering medium. The three-dimensional Cartesian coordinate system is used to solve the governing equations which are conservations of mass, momentum and energy. These equations...

متن کامل

Simulation of Steady, Laminar Flow Over a Backward-Facing Step

A 2D Navier-Stokes solver was developed to simulate steady,laminar flow over a backward-facing step of height h. The step expansion ratio=1/2 and the flow at the step was assumed to be fully developed, laminar channel flow. The Reynolds number for this flow was defined as Re=Uh/ν. The 2D incompressible Navier-Stokes equations was solved in generalized curvilinear coordinates using artificial co...

متن کامل

Investigation of entropy generation over a backward facing step under bleeding conditions

The current work investigates entropy generation around a backward facing step subjected to bleeding by using suction/blowing. The suction/blowing is imposed on the bottom wall of the step. Finite volume method with second order accuracy is used in the solution of the governing equations. The variation of local and overall entropy generation number is calculated. The distribution of entropy gen...

متن کامل

Numerical simulation of laminar to turbulent nanofluid flow and heat transfer over a backward-facing step

This paper presents a numerical study of heat transfer to turbulent and laminar Cu/water flow over a backward-facing step. Mathematical model based on finite volume method with a FORTRAN code is used to solve the continuity, momentum, energy and turbulence equations. Turbulence was modeled by the shear stress transport (SST) K–x Model. In this simulation, three volume fractions of nanofluid (0%...

متن کامل

Heat Transfer to Laminar Flow over a Double Backward-Facing Step

Heat transfer and laminar air flow over a double backward-facing step numerically studied in this paper. The simulations was performed by using ANSYS ICEM for meshing process and using ANSYS fluent 14 (CFD) for solving. The k-ɛ standard model adopted with Reynolds number varied between 98.5 to 512 and three step height at constant heat flux (q=2000 W/m2). The top of wall and bottom of upstream ...

متن کامل

POD analysis of flow over a backward-facing step forced by right-angle-shaped plasma actuator

PURPOSE This study aims to present flow control over the backward-facing step with specially designed right-angle-shaped plasma actuator and analyzed the influence of various scales of flow structures on the Reynolds stress through snapshot proper orthogonal decomposition (POD). METHODS 2D particle image velocimetry measurements were conducted on region (x/h = 0-2.25) and reattachment zone in...

متن کامل

منابع من

با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

ذخیره در منابع من قبلا به منابع من ذحیره شده

{@ msg_add @}


عنوان ژورنال

دوره 25  شماره 4

صفحات  379- 388

تاریخ انتشار 2012-10-01

با دنبال کردن یک ژورنال هنگامی که شماره جدید این ژورنال منتشر می شود به شما از طریق ایمیل اطلاع داده می شود.

میزبانی شده توسط پلتفرم ابری doprax.com

copyright © 2015-2023