Graphitic Carbon Nitride/Reduced Graphene Oxide/Silver Oxide Nanostructures with Enhanced Photocatalytic Activity in Visible Light

نویسندگان

  • Azar Daliri Department of Chemistry, Sharif University of Technology
  • Hadi Salari Department of Chemistry, College of Sciences, Shiraz University
چکیده مقاله:

Visible light active graphitic carbon nitride/reduced graphene oxide/silver oxide nanocomposites with a p-n heterojunction structure were synthesized by chemical deposition methods. Prepared samples were characterized by different physico-chemical technics such as XRD, FTIR, SEM, TEM and DRS. Photocatalytic activity investigated by analyzing the Acid blue 92 (AB92) concentration during the time under visible light. Effects of pH, dye concentration, photocatalyst dosage and different scavengers on photocatalytic performance explored. Maximum photocatalytic degradation observed at pH=7. Silver nitrate among other scavengers demonstrated maximum activity for dye degradation. Photocatalyst with 400 ppm concentration showed the highest activity. Proposed mechanism and reaction kinetics discussed.

برای دانلود باید عضویت طلایی داشته باشید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

New insight into the enhanced visible light photocatalytic activity over boron-doped reduced graphene oxide.

Boron-doped reduced graphene oxide (B-RGO) synthesized by a facile one-step reflux route is able to exhibit significantly higher photocatalytic activity than non-doped RGO under visible light irradiation. New insights accounting for this photocatalytic activity improvement are discussed, which is distinctly different from the case of B-RGO nanoribbons under UV light irradiation.

متن کامل

Visible-light active conducting polymer nanostructures with superior photocatalytic activity

The development of visible-light responsive photocatalysts would permit more efficient use of solar energy, and thus would bring sustainable solutions to many environmental issues. Conductive polymers appear as a new class of very active photocatalysts under visible light. Among them poly(3,4-ethylenedioxythiophene) (PEDOT) is one of the most promising conjugated polymer with a wide range of ap...

متن کامل

Nanotitania composite assembled with Graphene oxide for Photocatalytic degradation of Eosin Yellow under Visible light

Visible light responsive Graphene oxide (GO) nanotitania composite was synthesized and its photocatalytic activity was investigated for the degradation of Eosin Yellow (EY). The nanocomposite was synthesized by organic solvent free-controlled hydrolysis of titanium tetrachloride (TiCl4) exfoliated with 10 wt. % (0.5 g) of the as prepared GO particles under ultrasonication through in-situ additi...

متن کامل

Immobilizing photogenerated electrons from graphitic carbon nitride for an improved visible-light photocatalytic activity

Reducing the recombination probability of photogenerated electrons and holes is pivotal in enhancing the photocatalytic ability of graphitic carbon nitride (g-C3N4). Speeding the departure of photogenerated electrons is the most commonly used method of achieving this. To the best of our knowledge, there is no report on suppressing the recombination of photogenerated electron-hole pairs by immob...

متن کامل

Enhanced Photocatalytic Remediation Using Graphene (G)-Titanium Oxide (TiO2) Nanocomposite Material in Visible Light Radiation

The petroleum compounds were photocatalytically remediated from water using graphene (G)titanium oxide (TiO2) nanocomposite material in visible light radiation. The G-TiO2 nanocomposite was synthesized using sol-gel technique, and its structural & morphological properties were studied using scanning electron microscopy (SEM), X-ray diffraction (XRD), transmission electron microscopy (TEM), part...

متن کامل

Photocatalytic Activity with Visible Light Irradiation

Titanium dioxide (TiO2) was doped with the combination of several metal ions including platinum (Pt), chromium (Cr), vanadium (V), and nickel (Ni). The doped TiO2 materials were synthesized by standard sol-gel methods with the doping levels of 0.1 to 0.5 atom-%. The resulting materials were characterized by the X-ray diffraction (XRD), BET surface-area measurement, Scanning Electron Microscopy ...

متن کامل

منابع من

با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

ذخیره در منابع من قبلا به منابع من ذحیره شده

{@ msg_add @}


عنوان ژورنال

دوره 6  شماره 4

صفحات  729- 740

تاریخ انتشار 2018-12-01

با دنبال کردن یک ژورنال هنگامی که شماره جدید این ژورنال منتشر می شود به شما از طریق ایمیل اطلاع داده می شود.

میزبانی شده توسط پلتفرم ابری doprax.com

copyright © 2015-2023