Experimental and Numerical Investigation of Air Temperature Distribution inside a Car under Solar Load Condition

Experimental Investigation of Time Dependent Load Configurations inside of a Power Distribution System

Within the paper the procedures for carrying out detailed experimental investigations by the aid of digital Measurement Data Acquisition systems, for evaluating the measuring results as well as for aggregating the load type specific power consumption are pointed out in general form. The results received concerning the load type specific power consumption are presented and discussed in detail at...

Numerical Investigation of Circular Plates Deformation under Air Blast Wave

In the current research the maximum deflection of circular plates made of AA5010 and AA1100 alloys under blast load was investigated. Shock waves were produced by exploding a spherical charge in different distances from the center of plates. The ABAQUS software uses conwep equation for blast loading analysis. It was found the results of these simulations have about 30% to 40% inaccuracy in comp...

A Numerical and Experimental Investigation on Delamination Buckling Behavior in Laminated Composites under Compressive Load

Numerical investigation of the parameters of a prismatic lithium ion battery under load for electrical vehicle

Electric vehicles and hybrid electric vehicles are a suitable alternative for vehicles with hydrocarbons fuels to reduce pollution and fossil resources. The batteries operate as the driving force for these vehicles. One of the most critical parameters of the battery is computing the state of charge (SOC). The best range for SOC of lithium-ion battery is between 20% and 90%, and charging and dis...

A numerical and experimental study on buckling and post-buckling of cracked plates under axial compression load

Existence of cracks in industrial structures is one of the important causes of their failure, especially when they are subjected to important axial compressive forces that might lead to buckling. Therefore, it must be considered in stress analysis and designing and loading of such structures. In this paper, the buckling and post-buckling behaviors of stainless-steel cracked plates under axial c...

Experimental investigation of a solar desalination performance based on humidification-dehumidification technique with air and water closed cycle

In this study, the performance of solar desalination by humidification-dehumidification of closed air and water in Ahvaz city was investigated. This desalination includes a collector, condenser, salty water, freshwater tanks, air blower, and water pump. The evaluation of the system was done at three levels of air velocity (3, 4, and 5 m/s) and at three pump discharge levels (2, 4, and 6 liters/...