Detecting pitting corrosion and its severity using wavelet entropy in electrochemical noise measurement

detecting pitting corrosion and its severity using wavelet entropy in electrochemical noise measurement

entropy as a measure of uncertainty was used to represent the results of the wavelet technique in electrochemical noise analysis. the experimental signals were obtained by recording the electrochemical potential and current noise of 7075 aluminum alloy in 3.5% nacl solution. the electrochemical potential and current noise were decomposed into 16 levels using daubechies wavelets. wavelet output ...

Pitting Corrosion Monitoring Using Acoustic Emission

Corrosion Evaluation Using a New Electrochemical Impedance Measurement Technique

In this paper, a new approach to the computation of electrochemical impedance spectroscopy (EIS) is presented where the EIS system is represented by a convolutional model, and thus the impedance of the EIS system is computed using robust deconvolution algorithms. Very promising results are obtained .

Electrochemical Noise Analysis of Anaerobic (Bacterial) Corrosion of Steel

Corrosion of structural steel in an SRB containing environment for as long as 9 months, is studied using the Electrochemical Noise Analysis technique. The results show that the activity of the system, which was very low initially, started to increase after 6 months exposure to the environment. The power spectral density curves of the Electrochemical Potential Noise of the system, using the maxi...

Electrochemical Studies of Pitting Corrosion of Cu-fe Alloy in Sodium Chloride Solutions

The electrochemical studies of pitting corrosion of CuFe alloy (70% Cu30%Fe) were carried out in sodium chloride solutions. The techniques of measurements were: open circuit potential, potentiodynamic polarization and electrochemical impedance spectroscopy. The effect of different concentrations of the inorganic additives (WO4 , PO4 , NO2 , B4O7 , CrO4 ) on the pitting corrosion of the alloy in...

ELECTROCHEMICAL NOISE ANALYSIS OF 70-30 BRASS DURING STRESS CORROSION CRACKING TEST IN MATTSON S SOLUTION

An investigation of the electrochemical noise generation during Stress Corrosion Cracking (SCC) of 70-30 Brass in Mattson's solution was conducted. The fluctuations of potential and current were monitored. The relationship between potential and current fluctuations has been evaluated in time domain and the obtained data has been analyzed in the frequency domain using Power Spectral Density (PSD...