Delamination Wear Mechanism in Gray Cast Irons

ASM Specialty Handbook Cast Irons

A RESEARCH ON THE CALCULATION OF GRAPHITIZATION ABILITY OF GRAY CAST IRONS

In this research the relationship between graphitization ability and the carbon equivalent (CE %) of a cast iron have been investigated. The first series of moulds were cast at CE of 3.2% and pouring temperature of 1350°C. The other moulds were cast at different CE% with varying Si content. The graphitization ability( c ) was calculated using the thermodynamics aspects of graphitization and CE%...

Fatigue Behaviour of Synthetic Nodular Cast Irons

A. Vaško, L. Trško, R. Konečná, Faculty of Mechanical Engineering, University of Žilina, Žilina, Slovak Republic The paper shows the influence of charge composition on microstructure, fatigue properties and failure micromechanisms of nodular cast irons. The additive of metallurgical silicon carbide (SiC) in analysed specimens increases the content of ferrite in the matrix, decreases the size of...

Graphite Morphology’s Influence on Shot Peening Results in Cast Irons

The different shot peening responds of a grey cast iron (GI) with its flake graphite and a compacted cast iron (CGI) with its vermicular graphite was analyzed and compared in this paper. For peening using identical parameters, CGI showed a larger plastic deformation zone with higher subsurface compressive stresses than GI. Electron backscatter diffraction (EBSD) mapping and backscatter electron...

Microstructural characterization and kinetics modelization of vermicular cast irons

Several experimental techniques are used for phase identification and microstructure characterization of austempered vermicular cast irons (XRD, SEM, TEM and Mössbauer spectroscopy). Acicular structures were found to be composed by ferrite and austenite with average sizes compatible with those reported for bainitic ferrite in steels. An assessment of the free energy change involved in the auste...

Surface folding in metals: a mechanism for delamination wear in sliding.

Using high-resolution, in situ imaging of a hard, wedge-shaped model asperity sliding against a metal surface, we demonstrate a new mechanism for particle formation and delamination wear. Damage to the residual surface is caused by the occurrence of folds on the free surface of the prow-shaped region ahead of the wedge. This damage manifests itself as shallow crack-like features and surface tea...