Catalytic effect of Fe@Fe2O3 nanowires and Fenton process on carbamazepine removal from aqueous solutions using response surface methodology
نویسندگان
چکیده مقاله:
Carbamazepine is one of the hydrophilic compounds identified in aquatic environments. Due to toxicity and bio-stability of this psychotropic pharmaceutical in the environment and humans, its removal efficiency and mineralization are important. In this study, synthesized Fe@Fe2O3 nanowires were applied to improve Fenton oxidation process using FeCl3.6H2O and NaBH4. The effects of different parameters such as initial pH, H2O2, FeSO4.7H2O, carbamazepine concentrations, oxidation time, and nanowires dose were evaluated using response surface methodology. After scanning electron microscopy, energy-dispersive X-ray spectroscopy and X-ray diffract meter analysis, Fe@Fe2O3 morphology was synthesized in the form of nanowires with diameters of about 40-80 nm. The optimum oxidation conditions for carbamazepine were established at pH= 4.3, reaction time of 45.9 min, nanowire dose of 179.4 mg/L as well as H2O2, FeSO4.7H2O and carbamazepine concentrations of 22, 52.2 and 7.7 mg/L, respectively. The oxidation efficiency (99.5%) achieved under the optimum condition, which was determined by the model, was consistent with the efficiency predicted by the model. The multi-parameter models showed good calibration and prediction abilities with R2= 0.922, R2adj= 0.907, R2pred= 0.868. According to the results, the carbamazepine degradation rate increased with the increase of Fe2+ due to the synergistic effect between Fe@Fe2O3 and Fe2+ on the catalytic decomposition of H2O2 and generation of OH•. It was concluded that the Fenton process based on the Fe@Fe2O3 nanowires can increase the carbamazepine oxidation rate in aqueous solutions. This method can also be used as an effective and pre-treatment process in the conventional treatment plants.
منابع مشابه
Modeling and Optimization of Arsenic (III) Removal from Aqueous Solutions by GFO Using Response Surface Methodology
Arsenic is a highly toxic element for human beings, which is generally found in groundwater. Dissolved Arsenic in water can be seen as As+3 and As+5 states. The adsorption process is one of the available methods to remove Arsenic from aqueous solutions. Thus, this papers aims at removing Arsenic (III) from aqueous solutions through adsorption on iron oxide granules. The relation among four inde...
متن کاملModeling and Optimization of Arsenic (III) Removal from Aqueous Solutions by GFO Using Response Surface Methodology
Arsenic is a highly toxic element for human beings, which is generally found in groundwater. Dissolved Arsenic in water can be seen as As+3 and As+5 states. The adsorption process is one of the available methods to remove Arsenic from aqueous solutions. Thus, this papers aims at removing Arsenic (III) from aqueous solutions through adsorption on iron oxide granules. The relation among four inde...
متن کاملCd (II) Removal from Aqueous Solutions by Adsorption on Henna and Henna with Chitosan Microparticles Using Response Surface Methodology
In this research, the capabilities of Henna and Henna with chitosan microparticles adsorbents were studied in order to remove the ion Cd (II). Response Surface Method (RSM) and Central Composite Design (CCD) were used to minimize the number of experiments (21 runs) for Henna and (26 runs) for the Henna with chitosan microparticles. The parameters were pH (2-9), initial solution concentratio...
متن کاملRemoval of Diazinon from Aqueous Solutions in Batch Systems Using Cu-modified Sodalite zeolite: An Application of Response Surface Methodology
In this work, perlite was used as a low-cost source of Si and Al in the synthesis of sodalite zeolite using hydrothermal synthesis method. Cu2O nanoparticles were coated on a bed of sodalite zeolite and used as an adsorbent for removal of diazinon from aqueous solutions. To analyze the process, a significant variable .i.e. removal efficiency (%) of diazinon and three dependent parameters as the...
متن کاملRemoval of methylene blue from aqueous solution using nano-TiO2/UV process: Optimization by response surface methodology
This work describes the photocatalytic removal of methylene blue from aqueous solution by titanium dioxide nanoparticles under ultraviolet irradiation in a batch system. The effect of operational parameters such as irradiation time, nano titanium dioxide dosage, pH and initial methylene blue concentration were analyzed and optimized by response surface methodology in the nano titanium dioxide/u...
متن کاملBentazon removal from aqueous solution by reverse osmosis; optimization of effective parameters using response surface methodology
Although bentazon is widely used as an agricultural herbicide, it is harmful to humans and poses many environmental threats. This study focused on the treatment of wastewater contaminated with bentazon pesticides using membrane technology. In this regard, low-pressure reverse osmosis (RO) was employed as it has already been used in the removal of other micro-pollutants. The effects of process v...
متن کاملمنابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ذخیره در منابع من قبلا به منابع من ذحیره شده{@ msg_add @}
عنوان ژورنال
دوره 5 شماره 2
صفحات 213- 224
تاریخ انتشار 2019-04-01
با دنبال کردن یک ژورنال هنگامی که شماره جدید این ژورنال منتشر می شود به شما از طریق ایمیل اطلاع داده می شود.
میزبانی شده توسط پلتفرم ابری doprax.com
copyright © 2015-2023