حسین گل نبی

[ 1 ] - بررسی میکروسکوپ رقومی و کاربرد آن در شکل گیری تصویر و اندازه گیری

مجهّز به حِسهرر تصهویربردار

[ 2 ] - Weight Measurements by Using Simple Optical-Fiber Sensors (RESEARCH NOTE)

The use of different optical-fiber sensors for weighing measurements is Abstract described. By using three different mechanical stressing mechanisms, the operation of the fiber-to-fiber transducer systems are tested and the results are presented. Parameters such as sensitivity, hysteresis, resolution, and dynamic range are measured. A comparison of the results has shown that the sensor system m...

[ 3 ] - Power Supply and Current Modulation Circuits for Semiconductor Lasers

Design and construction of a stable current supply with protection circuits are described. The reported circuit provides a high-stable and high-level current variable from 0.5-1.2 A with the protect ion circuits to prevent over load current, voltage and off-range temperature operation. A detailed analysis of the circuit parameters is given and the time behaviors of the load voltage/current and ...

[ 4 ] - Design and Construction of a Sensitive Capasitive Sensor System (RESEARCH NOTE)

Design and construction of a capacitor sensor with a precise readout system are described in this paper. A variable air-gap capacitive transducer was constructed and for signalmeasurement a successful attempt was made to exploit the capacitance changes in terms of the phase angle of the detected signal. The reported setup makes it possible to detect capacitance changes of the order of 2.5 fF in...

[ 5 ] - The Study of Breakdown Voltages for Triggered Spark Gap Switches

This study explains the breakdown mechanism in different triggered spark gap switches. Two different trigger electrode configurations are tested for the switch predischarge operation in a nitrogen laser circuit. The behavior of the breakdown voltage, when a trigger pulse is applied to the trigger electrode, is investigated, and the results are reported. Based on the experimental measurements ne...

[ 6 ] - Fiber - Optic Sensing of Linear Thermal Expansion (RESEARCH NOTES)

The use of a LED fiber-optic sensor to measure displacement and linear thermal expansion is described. It has a sensitivity of about 0.6 mV/mm, a resolution of 1.25 mm, and a dynamic rang of 400 mm for displacement measurements. For thermal expansion, it shows a sensitivity of about 3.5 mV/C, and the experimental linear expansion values are in agreement with those calculated. The reported senso...

[ 7 ] - Theoretical Studies of Electrical Characteristics of the Nitrogen Laser

A theoretical analysis of the circuits for a nitrogen laser driven by the Blumlein or capacitor charge transfer transmission line is given in detail. The electrical characteristics of the charge line for a special case of resonant charging are discussed and the effects of various parameters on voltage and current are investigated. By using MICRO-CAP software the transient behavior of the curren...