A. Parvizi
Assistant Prof., Department of Mechanical Engineering, Tehran University, Tehran, Iran
[ 1 ] - Fluidity Onset Analysis in FG Thick-Walled Spherical Tanks under Concurrent Pressure Loading and Heat Gradient
In this paper,fluidity onset analysis in FG thick-walled spherical tanks under concurrent pressure loading and heat gradient has been presented. Designing thick-walled spherical tanks under pressure as tanks holding fluids under heat loads with high heat gradients require new approaches. Under high internal pressure and high temperature, the tank enters the plastic stage in a part of its thickn...
[ 2 ] - Investigation and Simulation of Wire Non-Asymmetric Rolling Process
The non-asymmetric rolling process of copper and brass wire has been simulated with the Abaqus software. Presented finite element model in this simulation of rolling predicted output curvature and contact surface width in the non-asymmetric mode (in equality of diameter of rollers, the rotational speed of the rollers and the rollers’ surface finish). The material used in this research has strai...
[ 3 ] - بررسی سایش گالینگ روی قالب‌های تولیدی ضربه‌ای حین کار با ورق فولادی پراستحکام پیشرفته
به منظور بهبود مقاومت بدنه و کاهش مصرف سوخت، در سال‌های اخیر، صنعت اتومبیل‌سازی بطور گسترده از فولادهای پراستحکام پیشرفته برای تولید اجزای مختلف بدنه خودرو استفاده می‌نماید. از سوی دیگر، استحکام بالاتر این نوع فولادها در مقایسه با فولادهای کشش عمیق مرسوم باعث شده تا به منظور شکل‌دهی ورق، فشار بالاتری به سطوح ابزار و قطعه کار اعمال شود. این مساله سبب کاهش طول عمر ابزار شده است. گالینگ، حالتی از...
[ 4 ] - Effect of the asymmetrical rolling process on the micro hardness and microstructure of brass wire
Current experimental investigation deals with the effects of asymmetrical rolling parameters on the inhomogeneity, microstructure, mechanical, and geometrical properties of rolled brass wire. Toward this end, a roll machine with three different roll radii ratios was set up. The asymmetrical conditions are arranged using three different sets of rolls with different diameters that result into dif...
[ 5 ] - Prediction and optimization of load and torque in ring rolling process through development of artificial neural network and evolutionary algorithms
Developing artificial neural network (ANN), a model to make a correct prediction of required force and torque in ring rolling process is developed for the first time. Moreover, an optimal state of process for specific range of input parameters is obtained using Genetic Algorithm (GA) and Particle Swarm Optimization (PSO) methods. Radii of main roll and mandrel, rotational speed of main roll, pr...
[ 6 ] - Elasto-plastic solution for thick-walled spherical vessels with an inner FGM layer
Purely elastic, partially and fully plastic stress states in a thick-walled spherical pressure vessel with an inner functionally graded material (FG) coating subjected to internal and external pressures are developed analytically in this paper. The modulus of elasticity and the uniaxial yield limit of the FG coating layer are considered to vary nonlinearly through the thickness. Using Tresca’s ...