Mojtaba Aghajani Delavar
Babol Noshirvani University of Technology
[ 1 ] - Energy Management Simulation in a PEM Fuel Cell System
In this research the simulation of an air independent Proton Exchange Membrane Fuel Cell (PEMFC) propulsion system was taken into consideration. The system consists of several parts including PEM fuel cell stack, metal hydride and liquid oxygen (LOX) tanks, and also pre-heaters of oxygen and hydrogen gases along with other heat exchangers, to ensure proper operation of system. The heat recovery...
[ 2 ] - Numerical Study of Bubble Separation and Motion Using Lattice Boltzmann Method
In present paper acombination of three-dimensional isothermal and two-dimensional non-isothermal Lattice Boltzmann Method have been used to simulate the motion of bubble and effect of wetting properties of the surface on bubble separation. By combining these models, three-dimensional model has been used in two-dimension for decreasing the computational cost. Firstly, it has been ensured that th...
[ 3 ] - Using Lattice Boltzmann Method to Investigate the Effects of Porous Media on Heat Transfer from Solid Block inside a Channel
A numerical investigation of forced convection in a channel with hot solid block inside a square porous block mounted on a bottom wall was carried out. The lattice Boltzmann method was applied for numerical simulations. The fluid flow in the porous media was simulated by Brinkman-Forchheimer model. The effects of parameters such as porosity and thermal conductivity ratio over flow pattern and t...
[ 4 ] - Investigation of Thermo-hydraulic Performance of Circular Tube Fitted with Center-cleared Twisted Tape Using CFD Modeling (RESEARCH NOTE)
The article presents a practical technique for enhancing thermo-hydraulic performance of a circular tube. In this way, numerical method focusing on laminar tubular flow is used to compare the effectiveness of utilizing center-cleared twisted tapes instead of typical shape of short width tapes. Numerical analysis represented that using both center-cleared and typical shape of twisted tapes, Re e...
[ 5 ] - Latent Heat Recovery in Exhaust Gas of a Condensing Boiler: The Effect of Arrangement of Tubes
Boilers are one of the major energy consumers in the building. For this reason, increasing the efficiency of this device and improving its performance is an effective step in solving the problems in building energy and reducing waste energy. Due to the limited resources of fossil fuels and the increasing cost of energy in the world, manufacturers of these equipment are always working to improve...
Co-Authors