Mohammad Reza Nilforoushan

Faculty of Engineering, Shahrekord University, Shahrekord, I.R. IRAN

[ 1 ] - The Study of Ion Adsorption by Amorphous Blast Furnace Slag

In this study, the blast furnace slag was used as absorbing bed and then, its ionic adsorption was studied. For this reason, various experimental parameters such as pH, contact time and the primary ion concentration were investigated. The remaining concentrations of ions such as; Mn2+ and Fe2+ in water were measured by atomic adsorption spectroscopy. The chemical and p...

[ 2 ] - Absorption of Lead Ions by Various Types of Steel Slag

Steel slags are the by products of steel industries, which forms during reduction process of iron melting. The chemical composition of it changes depending to the melting procedure. Its mineralogical composition also varies based on the cooling procedure. Two different types of steel slag were used as absorbing bed for various concentrations of Pb2+ ions in the form of lead chlor...

[ 3 ] - The Hydration Products of a Refractory Calcium Aluminate Cement at Intermediate Temperatures

The major hydraulic phase in all the calcium aluminate cements including ciment fondue is CA (CaAl2O4). Once hydrated, it starts to form the hexagonal crystals of CAH10 and C2AH8 that depending on the time and temperature of hydration convert to the cubic crystals of C3AH6 and AH3. The nature, sequence, ...

[ 4 ] - The Hydration Products of a Refractory Calcium Aluminate Cement at Low Temperatures

Calcium aluminates (CA) are the most important hydraulically setting cements used for preparing refractory castables, because they develop high strength at very early ages after placements.  The anhydrous phases of this kind of cements are CA, CA2 and traces of C12A7 and alpha-alumina. The major hydraulic phase in all of the CA cements including ciment fondu...

[ 5 ] - بررسی اثر افزودن کلرید منیزیم بر سینتیک تشکیل اسپینل آلومینات منیزیم

In this paper, the effect of MgCl2 addition on the kinetics of MA spinel formation was investigated. For this purpose, the stoichiometric mixture of MgCO3 and calcined aluminum was calcined at 1100 °C for 1 hr. Then, the calcined composition was wet-milled and after addition of 6% MgCl2 the compositions were pressed and fired at 1300 and 1500 °C for different times. Spinel phase content was de...

[ 6 ] - Synthesis and Investigation of Optical and Magnetic Properties of Co-Doped effect on Zinc Oxide Nanoparticles

In this study, the effect of simultaneous doping of magnesium, calcium, and copper ions on the properties of zinc oxide doped with cobalt was investigated. The sol-gel method has been used for the synthesis of nanoparticles. The structural and optical properties of the synthesized nanoparticles were investigated using X-ray diffraction (XRD), infrared spectroscopy (FTIR), and DRS spectroscopy. ...