Mohammad Reza Ehsani
Department of Chemical Engineering, Isfahan University of Technology, Isfahan 84156-83111, I.R. IRAN
[ 1 ] - Wettability Alteration of Oil- Wet and Water-Wet of Iranian Heavy Oil Reservoir by CuO Nanoparticles
The petroleum industry requires the best materials to reverse the rock wettability to water-wet state which give significantly improved oil recovery.Nanoparticles are suggested as enhanced oil recovery potential agents to decrease viscosity and alter the wettability of reservoir towards more water-wet. This study provides new insights into CuO nanoparticles effects on wett...
[ 2 ] - Modeling of Oxidative Coupling of Methane over Mn/Na2WO4/SiO2 Catalyst Using Artificial Neural Network
In this article, the effect of operating conditions, such as temperature, Gas Hourly Space Velocity (GHSV), CH4/O2 ratio and diluents gas (mol% N2) on ethylene production by Oxidative Coupling of Methane (OCM) in a fixed bed reactor at atmospheric pressure was studied over Mn/Na2WO4/SiO2 ca...
[ 3 ] - Kinetic Study of Ethyl Mercaptan Oxidation in Presence of Merox Catalyst
Mercaptans are commonly present in petroleum products. Their foul odor and highly corrosive nature make them the most undesirable sulfur compounds so they should be removed because of environmental issues. Merox process is used for oxidation of mercaptans to disulfide using air in the presence of alkaline solution and Merox catalyst. In this paper, due to lack of information about the kinet...
[ 4 ] - Effect of Additives on Mn/SiO2 Based Catalysts on Oxidative Coupling of Methane
The Oxidative Coupling of Methane (OCM) over M-Na-Mn/SiO2 catalysts (M=W, Cr, Nb and V) was investigated using a continuous-flow quartz reactor at 775°C, 1 atm and 100 cm3min-1 gas flow rates, and correlated with the observed structure and redox properties.The interaction effects of the metal-metal and metal-support on the...
[ 5 ] - Biodesulfurization of Tabas Coal in Pilot Plant Scale
Sulfur emission from coal combustion presents many environmental problems. The techniques used to reduce the amount of sulfur in coal before combustion, include physical, chemical and biological processes.Biological processes based on degradation of sulfur compounds by microorganisms offer many advantages over the conventional physical and chemical processes. The processes are performed und...
[ 6 ] - Microwave Assisted Synthesis of Nano Zeolite Seed for Synthesis Membrane and Investigation of its Permeation Properties for H2 Separation
MFI-type zeolite membranes (ZSM-5) were prepared on α-alumina tubular supports and tested for separation of H2/CO mixtures. The effect of pressure and temperature on H2 and CO flows and selectivity was investigated. The best results in this work were obtained with a ZSM-5 membrane prepared over a porous α-alumina tube seeded with zeolite nanocrystals synthesized with m...
[ 7 ] - Desulfurization of Tabas Coals Using Chemical Reagents
Large reserves of coal in Tabas region of Iran are characterized by low ash and high caking index, suitable for use in metallurgy as coking coal. However, these coals cannot be gainfully utilized because of their high sulfur content. In this work, studies on desulfurization of Tabas coals were carried out in a batch reactor using various reagents. The most effective reagents,<...
[ 8 ] - Bed Voidage and Heat Transfer in Non-Newtonian Liquid-Solid Fluidized Bed
The presence of particles in liquid-solid fluidized beds enhances the bed heat transfer, because the movement of the particles leads to an increased turbulence in the system. Moreover, the violent movement of the particles has a positive effect on fouling of the heat transfer surface. The aim of this investigation was to perform systematic measurements of bed voidage and heat transfer coeff...
[ 9 ] - Prediction of the Operating Conditions in a Batch Distillation Column Using a Shortcut Method
A shortcut procedure as quick, easy-to use method for design and simulation of multicomponent batch distillation is used to predict the operating condition of recovering xylene from solvent in an existing batch distillation column in benzol refinery. The procedure can be used to investigate the effect of the operating parameters on the operation of column for three possible modes of batch d...
[ 10 ] - An Experimental Study of Adsorption Breakthrough Curves for CO2/CH4 Separation in a Fixed Bed of Nanoporous Shaped Copper Trimesate Metal Organic Framework
Copper trimesate (Cu-BTC) MOF has been pointed out as a promising adsorbent for separating carbon dioxide from methane. However, MOF’s need to be shaped prior to their use in packed bed adsorbers in order to reduce pressure drop; on the other hand, the production of mechanically resistant shaped bodies reduces their adsorption performance. In this work, Cu-BTC tablets provided by BASF are evalu...
[ 11 ] - Reduction of Sulfur and Ash from Tabas Coal by Froth Flotation
Tabas mines in Iran have coal sources which are suitable for use in metallurgy industries as coking coal. But the high sulfur content of this coal imposes severe limitations on its utilization as the sulfur oxide gases evolved from the combustion of high sulfur coals result in acid rains and corrosion of equipments. In this work, attempts have been made to reduce sulfur from high sulfur coa...
[ 12 ] - بررسی آزمایشگاهی تأثیر افزودنی های پلیمری بر نقطه ریزش دیزل و نفت کوره تولیدی شرکت پالایش نفت اصفهان
یکی از مشکل های صنعت، پدیده ایجاد رسوب های واکسی مواد نفتی می باشد. یکی از راه‌های جلوگیری از ایجاد رسوب های واکسی، استفاده از بازدارنده شیمیایی برای کاهش نقطه ریزش می باشد. باوجود مطالعه های انجام گرفته یافتن افزودنی هایی که بتواند نقطه ریزش را کاهش دهد و از نظر اقتصادی به صرفه باشد و از نظر شیمیایی و زیست محیطی نیز در سطح بهینه و قابل قبولی باشد، مشکل است. در این مطالعه اثر افزودنی...
[ 13 ] - Prediction of the Products Yield of Delayed Coking for Iranian Vacuum Residues
In this work, new correlations are proposed to predict the products yield of delayed coking as a function of CCR and temperature based on the experimental results. For this purpose, selected Iranian vacuum residues with Conradson carbon residue (CCR) values between 13.40-22.19 wt.% were heated at a 10 °C/min heating rate and thermally cracked in a temperature range of 400-500 °C in a laboratory...
[ 14 ] - An Investigation into the Effect of Hydrotalcite Calcination Temperature on the Catalytic Performance of Mesoporous Ni-MgO-Al2O3 Catalyst in the Combined Steam and Dry Reforming of Methane
Several mesoporous nickel-based catalysts with MgO-Al2O3 as the catalyst support were prepared using a co-precipitation method at a constant pH. The supports were prepared from the decomposition of an Mg-Al hydrotalcite-like structure which had already been prepared with Mg/Al=1. Prior to impregnating 10 wt.% nickel on the supports, the precursor was decomposed at several ...
[ 15 ] - جذب مغزها
Co-Authors