Synthesis and thermoluminescence properties investigation of nano-structured alumina for high dose measurement
Authors
Abstract:
In this study, nanostructured alumina was synthesized by solution combustion method and its thermoluminescence properties was investigated. X-raydiffraction (XRD) and scanning electron microscopy (SEM) were conducted to investigate the crystal structure, morphology and the particle size of the powders. It was observed that nano structured α-Al2O3 particles with nano flake morphology and thickness of 50-90 nm were formed. The samples were exposed by gamma rays of 60Co radioactive source. The samples reproducibility and fading effect were investigated as well. The results of TL glow curves illustrated a prominent peak at around 187°C. It was revealed that the Al2O3 sample exhibited a linearity response in a wide range of doses (up to 4 kGy) that make it a good candidate for high dose dosimetry measurements.
similar resources
Synthesis and thermoluminescence properties of ZnS nanoparticle
In this scientific research ZnS nanoparticle was synthesized via precipitation method. Two samples were synthesized by this method. The nanoparticle was characterized by XRD techniques, and the size and kind of crystallinity were identified by X-ray diffraction pattern as well. The size measurement has been done by using scherrer's equation. The average sizes of nanoparticles in two sa...
full textnano-rods zno as an efficient catalyst for the synthesis of chromene phosphonates, direct amidation and formylation of amines
چکیده ندارد.
synthesis of amido alkylnaphthols using nano-magnetic particles and surfactants
we used dbsa and nano-magnetic for the synthesis of amido alkylnaphtols.
15 صفحه اولSynthesis and thermoluminescence properties of ZnS nanoparticle
In this scientific research ZnS nanoparticle was synthesized via precipitation method. Two samples were synthesized by this method. The nanoparticle was characterized by XRD techniques, and the size and kind of crystallinity were identified by X-ray diffraction pattern as well. The size measurement has been done by using scherrer's equation. The average sizes of nanoparticles in two sa...
full textInvestigation of the Effect of high Alumina Cement on the Properties of Foamed Alumina Insulation Bricks
The purpose of this study was to investigate the effect of high alumina cement and Sintering temperature on microstructure, physical and mechanical properties of foamed alumina insulation bricks. The Slurry samples were prepared containing 75wt% of alumina and 25% wt of deionised water containing 1%, 3%, 5%, 7% wt% high Alumina cement and 2% wt% foam. Then samples were poured into metal molds....
full textINFLUENCE OF NANO SILICA ON PROPERTIES AND MICROSTRUCTURE OF HIGH ALUMINA ULTRA-LOW CEMENT REFRACTORY CASTABLES
Colloidal silica bonded refractory castables have been developed recently. It was found that colloidal silica is one of the best binders can substitute other binders such as cement in No Cement Castable (NCC) and Ultra Low Cement Castable (ULCC) refractories. Also composition of colloidal silica with appropriate additives resulted in a gel form which makes the initial strength. Moreover, the na...
full textMy Resources
Journal title
volume 6 issue
pages 17- 22
publication date 2018-08
By following a journal you will be notified via email when a new issue of this journal is published.
No Keywords
Hosted on Doprax cloud platform doprax.com
copyright © 2015-2023