Source Rock evaluation, Modelling, Maturation, and Reservoir characterization of the Block 18 oilfields, Sab’atayn Basin, Yemen

Authors

  • A.F. Ahmed Taiz University, Faculty of Applied Sciences, Geology Department, Taiz 6803, Yemen.
  • A.S. Alaug Taiz University, Faculty of Applied Sciences, Geology Department, Taiz 6803, Yemen.
  • B. Bruns RWTH Aachen University, Inst. of Geology and Geochemistry of Petroleum and Coal, Germany.
  • D. Leythaeuser RWTH Aachen University, Inst. of Geology and Geochemistry of Petroleum and Coal, Germany.
Abstract:

A total of 183 core and cutting samples from seven exploratory wells were selected to be analyzed by Rock-Eval pyrolysis. These cores have been drilled through the Lam and Meem Members of the Madbi Formation and contain the major source rocks of Yemen´s sedimentary basins. Contents of total organic carbon were measured and Rock-Eval pyrolysis was performed to evaluate the hydrocarbon potential of Block 18 oilfields in central Yemen. Most of the studied samples have fair to excellent petroleum generation potential as shown by the results of PP, PI, HI and TOC. They have also sufficient TOC values with an average value of 1.48 wt% and a maximum value of 12.34 wt% with a good petroleum potential averaging 4.54 kg HC/ton of rock and a maximum value of 44.78kg HC/ton of rock. HI values of the Madbi Formation in its full thickness range from 16 mg to 1114 mg HC/g TOC with an average value of 273 mg HC/g TOC. Kerogen types II and III, and a small amount of type I can be observed. These kerogens are thermally mature and mostly within the hydrocarbon generation zone. In a numerical simulation approach the thermal and burial history of the Alif-1 well, which is representative for this area was modelled. Using vitrinite reflectance data, as means of calibration, the modelling results were subjected to a sensitivity analysis concerning paleo-heat flow, radiogenic heat production, basement thickness and eroded overburden or maximum burial, respectively. The calculated temperature during deepest burial of the source rock layers of the Madbi Formation reached 158 °C for the Lam Member and 182 °C for the Meem Member. Compliance with the measured R0 values, used as calibration parameter, could be achieved by assuming an erosion of 1100 m of the Upper Tawilah Group. The heat flow is maximized at the onset of basin rifting in Late Jurassic to 90 mW/m2 having a base level of 60 mW/m2. Thus, the Lam Member has reached the main oil to wet gas window at its deepest burial whereas the Meem Member has undergone the wet gas window in its full thickness. The isopach map of the Alif Member, as the main reservoir in the studied area, indicates thickening of the sandstone unit towards the eastern and western parts of Block 18 around the Dostour Al-Wahdah gasfield in the east and at the Alif oilfields in the west.

Upgrade to premium to download articles

Sign up to access the full text

Already have an account?login

similar resources

Organic Geochemical Evaluation of Madbi Source Rock, Al-Jawf Basin, NE Central Yemen

Organic geochemical evaluation of the Madbi Formation as the main source rock of the Al-Jawf Basin, NE Central Yemen was the main objective of this study. The organic geochemical methods used in the study include: rock-eval pyrolysis, total organic carbon, and optical measurements as the vitrinite reflectance and thermal alteration index. In this study, 67 well core and side-well core samples o...

full text

An Evaluation of Rock Integrity and Fault Reactivation in the Cap Rock and Reservoir Rock Due to Pressure Variations

Cap rocks are dams which can prevent the upward movement of hydrocarbons. They have disparities and weaknesses including discontinuities, crushed areas, and faults. Gas injection is an effective mechanism for oil recovery and pore pressure. With increasing pore pressure, normal stress is reduced, and the integrity of impermeable boundaries (cap rock, fault, etc.) becomes instable. A successful ...

full text

Reservoir Rock Characterization Using Wavelet Transform and Fractal Dimension

The aim of this study is to characterize and find the location of geological boundaries in different wells across a reservoir. Automatic detection of the geological boundaries can facilitate the matching of the stratigraphic layers in a reservoir and finally can lead to a correct reservoir rock characterization. Nowadays, the well-to-well correlation with the aim of finding the geological l...

full text

the evaluation of language related engagment and task related engagment with the purpose of investigating the effect of metatalk and task typology

abstract while task-based instruction is considered as the most effective way to learn a language in the related literature, it is oversimplified on various grounds. different variables may affect how students are engaged with not only the language but also with the task itself. the present study was conducted to investigate language and task related engagement on the basis of the task typolog...

15 صفحه اول

Source of Cement in the Great Oolite Reservoir, Storrington Oil Field, Weald Basin, South of England

The source of cement in oilfields is critical to the prediction of the distribution of cements in the reservoirs and also prediction of reservoir quality. The source of mineral forming cements has been determined for the Storrington oolitic carbonate reservoir (Middle Jurassic Great Oolite Formation, Weald Basin, onshore UK) using a combination of petrography, electron microscopy, fluid inclusi...

full text

My Resources

Save resource for easier access later

Save to my library Already added to my library

{@ msg_add @}


Journal title

volume 3  issue 2

pages  134- 152

publication date 2011-09-23

By following a journal you will be notified via email when a new issue of this journal is published.

Hosted on Doprax cloud platform doprax.com

copyright © 2015-2023