Moditication Factor for Sizing Equation of Electrical Machines-Single and Three Phase Induction Motors(RESEARCH NOTE)
Authors
Abstract:
Comparison between the results from the design procedure based upon the value of D2L (volume of iron) and IEC standard used by manufacturers indicates that the basic design equation of electrical machines must be modified by a proper modification factor. This modification factor is evaluated for single- and three-phase induction motors and its variation with motor rating and poles number is obtained and compared.
similar resources
A Novel Stand-Alone Single-Phase Induction Generator Using a Three-Phase Machine and a Single-Phase PWM Inverter
A new type of single-phase stand-alone induction generator using a three-phase induction machine and a single-phase voltage-source PWM inverter is introduced. The generator scheme is capable of producing constant load frequency with a very well regulated output voltage. A small lead acid battery and a single-phase full diode-bridge rectifier are used to feed the inverter. The inverter feeds one...
full textThree Meta-heuristic Algorithms for the Single-item Capacitated Lot-sizing Problem (RESEARCH NOTE)
This paper proposes a mixed integer programming model for single-item capacitated lot-sizing problem with setup times, safety stock, demand shortages, outsourcing and inventory capacity. Due to the complexity of problem, three meta-heuristics algorithms named simulated annealing (SA), vibration damping optimization (VDO) and harmony search (HS) have been used to solve this model. Additionally, ...
full textMathematical Modeling and Speed Torque Analysis of Three Phase Squirrel Cage Induction Motor Using Matlab Simulink for Electrical Machines Laboratory Mathematical Modeling and Speed Torque Analysis of Three Phase Squirrel Cage Induction Motor Using Matlab Simulink for Electrical Machines Laboratory
Different mathematical models have been used over the years to examine different problems associated with induction motors. These range from the simple equivalent circuit models to more complex d,q models and abc models which allow the inclusion of various forms of impedance and/or voltage unbalance. This paper presents speed torque characteristics of induction motor which are calculated on the...
full textComparison of Optimized PSS Using Three Different Methods for Single and Multi-Machines Systems
Oscillations of power systems cause instability in power networks. Power system stabilizer (PSS) is used as a conventional method to damp these oscillations . Finding the optimized gain of PSS is one of the major problems in power system stability issue. In this paper, single machine connected to an infinite bus and 10-machines 39-bus network are considered for study. it's shown that finding th...
full textdevelopment and implementation of an optimized control strategy for induction machine in an electric vehicle
in the area of automotive engineering there is a tendency to more electrification of power train. in this work control of an induction machine for the application of electric vehicle is investigated. through the changing operating point of the machine, adapting the rotor magnetization current seems to be useful to increase the machines efficiency. in the literature there are many approaches wh...
15 صفحه اولInvestigating Direct Torque Control of Six-Phase Induction Machines Under Open Phase Fault Conditions
This paper presents analysis and evaluation of classical direct torque control(DTC), for controlling a symmetrical six phase induction motor (SPIM) under open phasefault conditions. The machine has two three-phase windings spatially shifted by 60 electricaldegrees. The strategy of the proposed method consists of choosing the switching modesaccording to the configuration of living phases in such...
full textMy Resources
Journal title
volume 7 issue 3
pages 181- 184
publication date 1994-08-01
By following a journal you will be notified via email when a new issue of this journal is published.
Hosted on Doprax cloud platform doprax.com
copyright © 2015-2023