HYREP: A Hybrid Low-Power Protocol for Wireless Sensor Networks
Authors
Abstract:
In this paper, a new hybrid routing protocol is presented for low power Wireless Sensor Networks (WSNs). The new system uses an integrated piezoelectric energy harvester to increase the network lifetime. Power dissipation is one of the most important factors affecting lifetime of a WSN. An innovative cluster head selection technique using Cuckoo optimization algorithm has been used in the designed protocol. The residual energy of the nodes and the distances to the sink were used in the threshold calculations, besides to take advantage of the relay node for communication. A hybrid method using the optimized routing protocol and the integrated energy harvester results in 100% increase in the network lifetime compared to recent clustering-based protocols. The simulations results using MATLAB indicate that energy consumption was been decreased by more than 40%.
similar resources
A Radio Protocol for Low Power Wireless Sensor Networks
Radio transmission may be a good alternative to the wire based communication for a lot of applications in building automation (Rauchhaupt and Hähniche, 1999). The advantage is an easy, fast and low cost installation scenario. Nevertheless, the radio specifics require a very specialized protocol stack that affects the whole system architecture. Starting from the requirements of building automati...
full textPosition-based Routing Protocol for Low Power Wireless Sensor Networks
We present a table-less position based routing scheme for low power data centric wireless sensor networks. Our proposed scheme is localized, uses greedy forwarding approach, and does not rely on neighborhood information. These characteristics reduce the communication overhead (no neighborhood information exchange), make the protocol highly scalable (no routing tables are maintained and beacons ...
full textan efficient protocol for data aggregation in wireless sensor networks
sensor networks generally consist of a very great number of sensor nodes which will be spread into a vast environment and aggregate data out of it. the sensor nodes are afflicted with some limitations as follows memory, reception, communication as well as calculation capability, and battery power. the transmission of a great amount of extra data increases data transmission and proportionally in...
full textLow-Power Wireless Sensor Networks
Wireless distributed microsensor systems will enable fault tolerant monitoring and control of a variety of applications. Due to the large number of microsensor nodes that may be deployed and the long required system lifetimes, replacing the battery is not an option. Sensor systems must utilize the minimal possible energy while operating over a wide range of operating scenarios. This paper prese...
full textLow Power Design for Wireless Sensor Networks
Reference design for radio part is OKI’s ML7050LA [2] single chip RF having for example following blocks integrated: Low noise amplifier (LNA), power amplifier (PA), image rejection mixer (IMR). Block diagram of ML7050LA is in Figure 1. By assuming to use 3 V supply voltage Tx power dissipation is 102mW and Rx power dissipation is 165mW. Abstract—Wireless sensor networks have several challenges...
full textA Secure Routing Algorithm for Underwater Wireless Sensor Networks
Recently, underwater Wireless Sensor Networks (UWSNs) attracted the interest of many researchers and the past three decades have held the rapid progress of underwater acoustic communication. One of the major problems in UWSNs is how to transfer data from the mobile node to the base stations and choosing the optimized route for data transmission. Secure routing in UWSNs is necessary for packet d...
full textMy Resources
Journal title
volume 32 issue 4
pages 519- 527
publication date 2019-04-01
By following a journal you will be notified via email when a new issue of this journal is published.
Hosted on Doprax cloud platform doprax.com
copyright © 2015-2023