Evaluating of Refuse Derived Fuel (RDF) Production from Municipal Solid Waste (Case Study: Qazvin Province)
Authors
Abstract:
Considering increasing population growth in recent decades, and consequently, the increase in waste production in the world, waste management and efforts to reduce their harm to the environment has become an important issue. One of the appropriate ways to manage municipal waste is to generate energy from waste, especially by RDF production method. On the other hand, in order to reduce the consumption of fossil fuels in various industries that cause environmental pollution, alternative fuels have become one of the key issues among environmental researchers, for instance providing new fuels with less pollution to cement production plants which use coal as main fuel is increasing. In the present study, the feasibility of producing RDF as an energy supplier in cement factories has been evaluated. For this purpose, in 6 consecutive days, the wastes were collected from Qazvin city and physical and chemical analysis were performed on them. By using the proposed equations, the heating value of the existing waste is calculated. The results show that the heating value of RDF products from wastes is about 9100 Kj/Kg in summer and 9500 Kj/Kg in autumn, about thirty percent of coal heating value. Also by removing food wastes and using the five main RDFs material including paper, cardboard, plastics, PET, textiles, and wood, there will be a significant increase of heating value about 110% compared to the presence of food wastes.
similar resources
A New Processing System for the Production of Improved Refuse Derived Fuel and Recyclables from Municipal Solid Waste
The following are the questions and comments on the paper. (a) An energy balance could be provided to help clarify the cost of operating the system. Drying the refuse is likely very expensive. (b)The paper indicates that conventional RDF systems have trouble processing rugs, mattresses, wire, plastic sheets, etc.; however, the UAH system would appear to have similar difficulties with these mate...
full textRDF Production from Municipal Wastes (Case Study: Babol City)
Today, with the advancement of technology, turning waste into fuel has been considered as an inexhaustible source of energy production, especially in industries with high energy consumption. The most important of these industries are Cement and Iron Smelting factories. Babol, as one of the largest provinces in the north of the country, has been facing waste management crisis for several years w...
full textThe assessment of reuse potential for municipal solid waste and refuse-derived fuel incineration ashes
Resource recovery plants with a waste presorting process prior to incineration have not been successfully implemented in many developing countries. At least two engineering projects were fully assessed in Taiwan for the possible installation of presorting facilities in order to increase the potential efficiency of material and energy recovery for municipal incinerators. But the reuse potential ...
full textMethane Production from Municipal Solid Waste
Introduction Archaeological investigations of landfills have revealed that biodegradable wastes can be found — virtually intact — 25 years after burial. We know that landfills contain bacteria with the metabolic capability to degrade many of the materials that are common components of municipal refuse. The persistence for decades of degradable materials in the presence of such organisms appears...
full textElemental balance of SRF production process: solid recovered fuel produced from municipal solid waste.
In the production of solid recovered fuel (SRF), certain waste components have excessive influence on the quality of product. The proportion of rubber, plastic (hard) and certain textiles was found to be critical as to the elemental quality of SRF. The mass flow of rubber, plastic (hard) and textiles (to certain extent, especially synthetic textile) components from input waste stream into the o...
full textHydrothermal Treatment of Municipal Solid Waste to Produce Solid Fuel
This paper describes the application of innovative hydrothermal technology on local municipal solid waste (MSW) to produce low chlorine content solid co-firing fuel with coal. Raw MSW was treated at temperatures ranging from 210 to 235°C with 30 to 90 minutes holding period. The process yielded slump products which were then naturally dried to 5% moisture content, resulted in dry products with ...
full textMy Resources
Journal title
volume 4 issue 2
pages 97- 109
publication date 2020-05-01
By following a journal you will be notified via email when a new issue of this journal is published.
Hosted on Doprax cloud platform doprax.com
copyright © 2015-2023