Detection of fault segments based on P–T dihedra analysis along the North Tabriz fault, NW Iran

The mafic rocks along the North Tabriz Fault, possible remnants of Neo-Tethys oceanic crust in NW Iran

The North Tabriz Fault is seismologically an active fault with current right lateral strike-slip movements. Restricted mafic to intermediate Late Cretaceous igneous rocks are exposed along the North Tabriz Fault. Whole rock samples and clinopyroxene phenocrysts geochemistry were studied in order to characterize the petrogenesis of these mafic rocks and their possible relation to an oceanic crus...

A comparison between the Kazerun (Iran) and the North Anatolian (Turkey) fault systems in fault interaction and seismicity migration based on the spatiotemporal analysis of earthquakes

The Kazerun Fault System (KFS) is a right-lateral strike slip fault system in the middle part of the Zagros seismogenic zone in Iran. Historical and instrumental earthquake data catalogs of this fault system show good evidence of fault interactions and seismic migrations. This study provides evidence for the migration of seismicity in the middle part of the Zagros region along the segments of t...

Structural concepts for Soltanieh fault zone (NW Iran)

Active deformation in Alborz range is due to N-S convergence between Arabia and Eurasia. This paper provides geomorphic traces of regional deformation in NW Iran in order to characterize active faulting on major faults. Soltanieh and North Zanjan fault systems are involved in convergence boundary extent between South Caspian Basin and Central Iran. Soltanieh and North Zanjan faults are major re...

Ground-penetrating radar investigation along Pinjore Garden Fault: Implication toward identification of shallow subsurface deformation along active fault, NW Himalaya

CURRENT SCIENCE, VOL. 93, NO. 10, 25 NOVEMBER 2007 1422 *For correspondence. (e-mail: [email protected]) vertical measurements. Also, the time taken by the different stochastic methods is compared. The longer data spans give reliable results as well as less standard deviation for residuals. Using the single-frequency receiver, the standard deviation of the residuals is the same for all three sto...

Analog Fault Detection based on Statistical Analysis

In analog circuits, process variations result in physical parameter variations. Simulated values must then be considered with there tolerance intervals. Consequently, contrarily to digital circuits where the outputs are either '0' or '1' such that we can decide without ambiguity whether a fault is detectable or not, for analog circuits the fault detectability is a vague problem as the fault can...

A Fault Slip Transient on the North Anatolian Fault