Design and Simulation of Double Loop Control for Power Converter Fed Variable Speed DC Drive
Authors
Abstract:
This article doesn't have abstract
similar resources
Design of Soft Switching Sepic Converter Fed DC Drive Applications
High efficiency DC-DC converters with high-voltage gain have been researched due to increasing demands. A soft-switching single-ended primary inductor converter (SEPIC) is presented in this work. An auxiliary switch and a clamp capacitor are presented in this project. A coupled inductor and an auxiliary inductor are utilized to obtain ripple-free input current and achieve zero voltage-switching...
full textCurrent-fed double inductor push-pull DC/DC converter with closed loop control system
In order to use hydrogen fuel cells in domestic applications either as main power supply or backup source, their low DC output voltage has to be matched to the level and frequency of the utility grid AC voltage. Such power converter systems usually consist of a DC-DC converter and a DCAC inverter. A double inductor step-up push-pull converter with the output voltage and the input current contro...
full textDesign Modelling Control and Simulation of DC/DC Power Buck Converter
Abstract—The power buck converter is the most widely used DC/DC converter topology. They have a very large application area such as DC motor drives, photovoltaic power system which require fast transient responses and high efficiency over a wide range of load current. This work proposes, the modelling of DC/DC power buck converter using state-space averaging method and the current-mode control ...
full textDesign and Simulation of a New DC Power Supply Based on Dual Bridge Matrix Converter
A conventional high power DC power supply systems consist of a three-phase diode rectifier followed by a high frequency converter to supply loads at regulated DC voltage. These rectifiers draw significant harmonic currents from the utility, resulting in poor input power factor. In this paper, a DC power supply based on dual-bridge matrix converter (DBMC) with reduced number of switches is p...
full textModern Topology& Thermal Analysis of Drive for Variable Speed Pumped Storage Power Plant
Given the significant power generation and consumption of variable-speed pumped storage power plants (VSPSPs), it is crucial to enhance drive methods and decrease drive losses, thereby increasing productivity. This paper proposes the topology for VSPSP drivers with two level voltage source converters (2LVSC) with 6+1 converters. Hydraulic and electrical VSPSP models are presented, following whi...
full textSpeed Control Based on Adaptive Fuzzy Logic Controller For AC-DC Converter Fed DC Motor Drives
This paper presents fuzzy logic control (FLC) based speed control system for a DC Motor drive through the use of Genetic optimization. The control system design and implementation procedures of DC motor drive using Digital Signal Processor are described. Results of simulation and experimental on the real control system demonstrated that the proposed FLC is able to overcome the disadvantage of u...
full textMy Resources
Journal title
volume 6 issue 1
pages 2- 2
publication date 2018-07-01
By following a journal you will be notified via email when a new issue of this journal is published.
Hosted on Doprax cloud platform doprax.com
copyright © 2015-2023