Comparison of the solubility of three resin cements and a resin-modified glass ionomer cement: An in vitro study
Authors
Abstract:
Background and aims: Solubility is an important property of luting cements in determining clinical durability. The aim of this study was to compare the solubility of Panavia, Calibra and Maxcem resin cements with that of GC Fuji PLUS resin modified glass ionomer cement in three different pH values. Materials and Methods: A total of 96 specimens were prepared (8mm diameter, 4mm thickness) according to manufacturer instructions. After setting, they were desiccated and weighed. The specimens were kept immersed in distilled water and lactic acid solution (pH values of 3 and 5) for 30 days and then removed and weighed again. Data were statistically analyzed by SPSS18 using two-way ANOVA with P≤0.05 set as the level of significance. Results: The results of this study showed no significant difference between three pH values (P=0.08). The Calibra resin cement had the lowest value of solubility in distilled water and both pH of lactic acid. GC Fuji PLUS resin modified glass ionomer cement had the highest value of solubility in lactic acid and the Maxcem resin cement had the highest value of solubility in water. Conclusion: The solubility characteristics of resin modified glass ionomer and three different resin cements were significantly affected by their composition and the storage condition.
similar resources
The Effect of Cigarette Smoking on Solubility and Disintegration of Resin Modified Glass Ionomer Cement – An In Vitro Study
Introduction: Glass ionomer cement (GIC) is a dental restorative material that is prone to solubility and degradation. GIC could degrade in presence of water and desiccation due to environmental factors during setting process and eventually might lead to the failure of the restoration. Cigarette smoking brings a complex chemical mixture to oral cavity that can inhibit polymeriz...
full textComparison of the solubility of conventional glass ionomer and modified cements: An in vitro study
Comparison of the solubility of conventional glass ionomer and modified cements: An in vitro study Dr. H. Torabzadeh* - Dr. S. Bai** *- Associate Professor of Operative Dentistry Dept. - Faculty of Dentistry – Shaheed Beheshti University of Medical Sciences. ** - Dentist. Background and Aim: Solubility of restorative materials leads to loss of marginal intergrity, surface properties and aesthet...
full textComparison of the Amount of Fluoride Release from Nanofilled Resin Modified Glass Ionomer, Conventional and Resin Modified Glass Ionomer Cements
OBJECTIVE To investigate and compare the amount of fluoride release of conventional, resin modified and nanofilled resin modified glass ionomer cements. MATERIALS AND METHODS Tablets of glass-ionomer cements were immersed in deionized water and incubated at 37°C. After 1, 2, 7, 15 and 30 days, fluoride ion was measured under normal atmospheric conditions by fluoride ion selective electrode. B...
full textA comparison of the in vitro cytotoxicity of conventional and resin modified glass ionomer cements.
To evaluate cytotoxicity of experimental conventional and resin modified glass-ionomer cements on UMR-106 osteoblast cell cultures and cell cultures of NIH(3)T(3) mouse fibroblasts specimens were prepared for every experimental material and divided into: group 1.Conventional glass-ionomer cements: GC Fuji IX GP Fast, GC Fuji Triage and Ketac Silver; group 2. Resin modified glass-ionomer cements...
full textShear bond strength evaluation of resin composite to resin-modified glass-ionomer cement using three different resin adhesives vs. glass-ionomer based adhesive
Background: The clinical success of sandwich technique depends on the strength of resin-modified glass ionomer cement (RMGIC) bonding to both dentin and resin composite. Therefore, the shear bond strength (SBS) of resin composite bonded to RMGIC utilizing different resin adhesives versus a GIC-based adhesive was compared. Materials and methods: In this in vitro study, 84 holes (5×2 mm) were pre...
full textA Comparative Study of the Solubility and Sorption Properties of Resin Modified Glass Ionomer and a Bioactive Liner
Background and Aim: This study aimed to compare the sorption and solubility properties of ACTIVA BioACTIVE liner and resin modified glass ionomer (RMGI). Materials and Methods: In this in vitro study, a total of 30 samples were fabricated from each liner measuring 15 mm in diameter and 1 mm in thickness according to ISO 2009:4049. They were then divided into 6 subgroups (n=5) to assess th...
full textMy Resources
Journal title
volume 32 issue 3
pages 156- 162
publication date 2019-12
By following a journal you will be notified via email when a new issue of this journal is published.
No Keywords
Hosted on Doprax cloud platform doprax.com
copyright © 2015-2023