Biodegradation of high concentrations of phenol by baker’s yeast in anaerobic sequencing batch reactor
Authors
Abstract:
Background: Phenol, as a pure substance, is used in many fields because of its disinfectant, germicidal, local anesthetic, and peptizing properties. Aqueous solutions of phenol are produced as waste in industries and discharged into the environment. Therefore, elevated concentrations of phenol may be found in air or water because of industrial discharge or the use of phenolic products. Method: The strains of Saccharomyces cerevisiae used in this project were natural strains previously purchased from Razavy company. They were grown at 30°C on Petri plates containing yeast extract glucose (YGC) and then purified by being spread onto new plates, and isolated colonies were obtained. These colonies provided the basis of selection. Prepared strains were applied in anaerobic sequencing batch reactors (ASBRs) as first seed. The experiment conditions were optimized using response surface methodology (RSM). After the determined runs were performed using Design-Expert software, data were analyzed using mentioned software as well. Results: This study evaluated the capability of baker’s yeast to remove phenol in high concentrations. The tested strains showed excellent tolerance to phenol toxicity at concentrations up to 6100 mg/L. Study of the batch degradation process showed that the phenol removal rate could exceed 99.9% in 24 hours at a concentration of 1000 mg/L. The results showed catechol is the first intermediate product of phenol degradation. In survey results of the Design–Expert software, R2 and Adeq precision were 0.97 and 25.65, respectively. Conclusion: The results demonstrated that ASBR performs robustly under variable influent concentrations of inhibitory compounds. The high removal performance despite the high phenol concentration may be a result of reactor operating strategies. Based on the progressive increase of inlet phenol concentration, allowing for an enhanced biomass acclimation in a short time, results at the microbiological levels showed that the increase of phenol concentration was accompanied by a decrease in the microbial community and a progressive selection of the most adapted phenotypes.
similar resources
biodegradation of high concentrations of phenol by baker’s yeast in anaerobic sequencing batch reactor
background: phenol, as a pure substance, is used in many fields because of its disinfectant, germicidal, local anesthetic, and peptizing properties. aqueous solutions of phenol are produced as waste in industries and discharged into the environment. therefore, elevated concentrations of phenol may be found in air or water because of industrial discharge or the use of phenolic products. method: ...
full textBiodegradation of Linear Alkyl Benzene Sulfonate by Sequencing Batch Reactor in Sanitary Wastewater
Introduction: Detergents lead to many environmental problems. The main aim of this study was to evaluate sequencing batch reactor (SBR) efficiency on Linear alkyl benzene sulfonate (LAS) removal. Materials and Methods: In this experimental study, to investigate the removal efficiency of LAS, a SBR reactor was used. A roughly 12-hour operating cycle was chosen which included the discharge time ...
full textPerformance of Anaerobic Baffled Reactor for Biodegradation of Phenol
(Received: June 5, 2011; Accepted: July 29, 2011) Abstract: Effect of increase in phenol concentration on performance of anaerobic baffled reactor in terms of chemical oxygen demand (COD), phenol and COD removal efficiency and biogas productions was investigated. Furthermore, stability of the reactor with respect to the chemical shock load was monitored. The anaerobic baffled reactor was contin...
full textBiodegradation of tannery wastewater using sequencing batch reactor--respirometric assessment.
This investigation proved that respirometry combined with sequencing batch reactor (SBR) could be an effective way for the removal of COD in tannery wastewater. Measurement of oxygen uptake rates (OUR) and corresponding COD uptake rates showed that a 12-h operating cycle was optimum for tannery wastewater. The removal of COD by degradation was stoichiometric with oxygen usage. A plot of OUR val...
full textbiodegradation of linear alkyl benzene sulfonate by sequencing batch reactor in sanitary wastewater
introduction:detergentsleadtomanyenvironmentalproblems.themainaimofthisstudywastoevaluatesequencingbatchreactor(sbr)efficiencyonlinearalkylbenzenesulfonate(las)removal. methods:inthisexperimentalstudy,toinvestigatetheremovalefficiencyoflas,asbrreactorwasused.aroughly12-houroperatingcyclewaschosenwhichincludedthedischargetime(30min),thefillingtime(60min),andsedimentation(1hr),whiletheremainingti...
full textPretreatment of coking wastewater using anaerobic sequencing batch reactor (ASBR).
A laboratory-scale anaerobic sequencing batch reactor (ASBR) was used to pretreat coking wastewater. Inoculated anaerobic granular biomass was acclimated for 225 d to the coking wastewater, and then the biochemical methane potential (BMP) of the coking wastewater in the acclimated granular biomass was measured. At the same time, some fundamental technological factors, such as the filling time a...
full textMy Resources
Journal title
volume 2 issue None
pages 79- 86
publication date 2015-06
By following a journal you will be notified via email when a new issue of this journal is published.
Hosted on Doprax cloud platform doprax.com
copyright © 2015-2023