Appropriate Loading Techniques in Finite Element Analysis of Underground Structures
author
Abstract:
Stability of underground structures is assessed by comparing rock strength with induced stresses resulted from ground stresses. Rock mass surrounding the opening may fail either by fracture or excessive deformation caused. Accurate calculation of induced stresses is therefore fundamental in the stability analysis of an opening. Although numerical methods, particularly finite element method, are very promising methods in finding out induced stresses, special care must be taken at various stages of constructing and analysing such models. This paper describes the significance of loading technique; the way that ground stresses are applied to the finite element model in finite element analysis (FEA) of underground structures. The purpose of this research is to illustrate the results obtained from similar models which were constructed in different ways regarding the loading technique. Key factors for choosing an appropriate loading method whilst considering the in-situ condition of the structure are addressed. To carry out this investigation, the three-dimensional finite element program, NASTRAN, was used. The results of FE models were compared with those obtained from closed solution methods as well as field investigations conducted both during this research and reported by others. Based on the results of this study, appropriate loading techniques are developed and suggested for various conditions. The application of these techniques to the stability analysis of underground structures resulted in encouraging findings.
similar resources
A boundary element/finite difference analysis of subsidence phenomenon due to underground structures
Analysis of the stresses, displacements, and horizontal strains of the ground subsidence due to underground excavation in rocks can be accomplished by means of a hybridized higher order indirect boundary element/finite difference (BE/FD) formulation. A semi-infinite displacement discontinuity field is discretized (numerically) using the cubic displacement discontinuity elements (i.e. each highe...
full texta boundary element/finite difference analysis of subsidence phenomenon due to underground structures
analysis of the stresses, displacements, and horizontal strains of the ground subsidence due to underground excavation in rocks can be accomplished by means of a hybridized higher order indirect boundary element/finite difference (be/fd) formulation. a semi-infinite displacement discontinuity field is discretized (numerically) using the cubic displacement discontinuity elements (i.e. each highe...
full textFinite Element Analysis for CFST Columns under Blast Loading
The columns of frame structures are the key load-bearing components and the exterior columns are susceptible to attack in terrorist blasts. When subjected to blast loads, the columns would suffer a loss of bearing capacity to a certain extent due to the damage imparted which may lead to their collapse and even cause the progressive collapse of the whole structure . The concrete-filled steel col...
full textFinite Element Analysis of Solids and Structures
The finite element method is a numerical method for obtaining approximate solutions for boundary value problems that are defined in terms of a set of governing mathematical equations, boundary and/or initial conditions, constitutive laws and other secondary relations such as the strain-displacement relations. In general, any one of a number of different principles (e.g., virtual work principle,...
full textFinite Element Analysis of Different Hip Implant Designs along with Femur under Static Loading Conditions
Background: The hip joint is the largest joint after the knee, which gives stability to the whole human structure. The hip joint consists of a femoral head which articulates with the acetabulum. Due to age and wear between the joints, these joints need to be replaced with implants which can function just as a natural joint. Since the early 19th century, the hip joint arthroplasty has evolved, a...
full textMy Resources
Journal title
volume 11 issue 1
pages 43- 52
publication date 1998-02-01
By following a journal you will be notified via email when a new issue of this journal is published.
Hosted on Doprax cloud platform doprax.com
copyright © 2015-2023