An Experimental Investigation into the Arching Effect in Fine Sand
Authors
Abstract:
In the current paper results of a well instrumented experimental procedure for studying the arching effect in loose and dense sand are presented. The apparatus comprises concentric circular trapdoors with different diameters that can yield downward while stresses and deformations are recorded simultaneously. As the trapdoor starts to yield, the whole soil mass deforms elastically. However, after an immediate specified displacement, depending on the diameter of the trapdoor and relative density of the soil, the soil mass behaves plastically. This behavior of sand occurs due to flow phenomenon and continues until the stress on trapdoor is minimized. Then the failure process develops in sand and the measured stress on the trapdoor shows an ascending trend. This indicates gradual separation of the yielding mass from the whole soil body. Finally, the flow process leads to establish a stable vault of sand called arching mechanism. Depending on the trapdoor diameter there is a critical relative density at/above which the test leads to form a stable arch. A mathematical method to establish the shape of the sand vault is introduced and the results obtained from experimental investigations are compared to this method. The results are also, compared to Terzaghi's theory and the assumption of upper boundary solution is discussed.
similar resources
an investigation into iranian teachers consistency and bias in evaluation of students writings
while performance-based language assessment has led to an increased authenticity and content validity in the practice of writing assessment, the reliability of ratings has become a major issue. research findings have shown different reactions by native english speaker (nes) and non-native english speaker (nns) teachers to students’ writings. the focus of this study is on investigating whether i...
Experimental Investigation of Friction Coefficient in Ribleted Pipes and the Effect of Fine Particles
The effect of fine particles on turbulence damping and reduction of flow friction coefficient in ribleted pipes, have been investigated experimentally. Tests have been conducted in a ribleted pipe with hydraulic diameter of 18.6 mm, and 20 stream wise riblets of 1.8 mm depth, along the pipe. Flows of water tap with Reynolds number from 5000 to 30000 were compared with flows containing silt-clay...
full textFrictional Strain Hardening-softening in Experimental and Numerical Investigation of Arching Effect
In the current paper the results of a numerical simulation that were verified by a well instrumented experimental procedure for studying the arching effect over a trapdoor in sand is presented. To simulate this phenomenon with continuum mechanics, the experimental procedure is modeled in ABAQUS code using stress dependent hardening in elastic state and plastic strain dependent frictional harden...
full textexperimental investigation on the arching effect in granular materials by using the developed trapdoor apparatus
this paper discusses the arching effect as the formation of a stable arch in granular materials. for this aim, a developed trapdoor apparatus is designed in order to investigate the arch dimensions in term of the internal friction angle, average size and base angle of materials. observations show that for all tested granular ensembles, width and height of the arch increase with an increase in t...
full textAn Investigation into the Use of Manufactured Sand as a 100% Replacement for Fine Aggregate in Concrete
Manufactured sand differs from natural sea and river dredged sand in its physical and mineralogical properties. These can be both beneficial and detrimental to the fresh and hardened properties of concrete. This paper presents the results of a laboratory study in which manufactured sand produced in an industry sized crushing plant was characterised with respect to its physical and mineralogical...
full textExperimental and Numerical Studies of Load Transfers and Arching Effect
Experimental and numerical tests of the trap-door problem have been carried out, involving several granular materials. Three phases have been observed in the load transfer mechanism, as the trap-door is moved downward. The classical pattern for the description of this type of problem (a vertical plane of failure at each edge of the trap-door) corresponds to the third phase observed. The previou...
full textMy Resources
Journal title
volume 21 issue 4
pages 345- 360
publication date 2008-12-01
By following a journal you will be notified via email when a new issue of this journal is published.
Hosted on Doprax cloud platform doprax.com
copyright © 2015-2023