Activated Carbon from Olive Wastes as an Adsorbent for Chromium Ions Removal
Authors
Abstract:
Adsorption of Chromium ions (VI) and (III) in aqueous solution was investigated using activated carbon prepared from olive wastes, by one step physical activation with steam. After adsorbent material characterization using adsorption capacity of methylene blue, iodine and phenol, BET surface area, Fourier Transform InfraRed (FT-IR) spectroscopy, pHpzc, surface functions based on the Boehm method and, Scanning Electron Microscopy (SEM), the effect of different parameters (initial pH, absorbent dosage, initial concentration of solutes, time) on the adsorption of chromium ions were carried out in a batch system. The obtained activated carbon has a large specific surface area of 1050,9 m2/g and good adsorption capacity for iodine (1017 mg/g) and methylene blue MB (349 mg/g), which confirm that its structure is essentially composed of micropores (61 % of the surface) and mesopores. It has a basic chemical nature. Experimental results showed that the adsorption capacity of the prepared activated carbon was strongly dependent on solution pH. It was found that the initial pH of 2.0 was most favorable for Cr(VI) adsorption, and basic pH was best for Cr(III) removal. The adsorption process was studied using two kinetic models (pseudo-first order and pseudo-second order) and three functions isotherms (Langmuir, Freundlich, Temkin). The results showed that the adsorption process follows the pseudo-second order kinetics and the adsorption data were found to agree with the Langmuir isotherm model. Maximum adsorption capacity for Cr (VI) was 74,9 mg/g at pH 2, and 14,3 mg/g at pH 9 for Cr (III), and was comparable to results reported by other researchers working on activated carbon prepared from various solid wastes. Temperature effect was determined using the thermodynamic parameters. Negative values of ΔH0 and ΔG0 proved the feasibility of the adsorption process with its spontaneous and exothermic natures. Tests of desorption were performed in three different media: neutral (distilled water), acidic (2N hydrochloric and acetic acid solutions) and alkaline (2N NaOH solution). The magnitudes of desorption efficiency in the acetic acid medium were 94% and 71% for Cr(VI) and Cr(III) respectively.
similar resources
Preparation and Characterization of Activated Carbon derived from olive stone as adsorbent for Congo Red
Carbon activated powdered was prepared from activated carbon derived from olive stone. Then byusing the surface methodology, many parameters such as pH, furnace temperature (T), acid ratio,time of activation that affect on the qualities prepared activated carbon produced and its efficiencywere investigated. In addition, the adsorption of Congo Red onto the activated olive stone carbonactive was...
full textThe Perlite-calcium Alginate-activated Carbon Composite as an Efficient Adsorbent for the Removal of Dyes from Aqueous Solutions
To remove dyes from wastewater, the perlite-calcium alginate–activated carbon (PCA) composite was prepared by a simple method. This composite was characterized by FTIR, XRD, SEM, and BET techniques. A high capacity of PCA was observed for the adsorption of some dyes such as methylene blue (MB) and methyl orange (MO) from aqueous solutions (1111 and 909 mg g-1). The best results were achieved at...
full textMagnetic Multi-Walled Carbon Nanotube as an Adsorbent for Toluidine Blue O Removal from Aqueous Solution
Toluidine Blue O (TBO) is a cationic dye which is extensively used in the industries. In the present paper a simple and efficient wet chemical method was introduced for removal of TBO from waste aqueous solution. Magnetic multi-walled carbon nanotubes were synthesized using commercially available multi-wall carbon nanotubes and magnetic iron oxide nanoparticles which were examined for removal o...
full textpreparation and characterization of activated carbon derived from olive stone as adsorbent for congo red
carbon activated powdered was prepared from activated carbon derived from olive stone. then byusing the surface methodology, many parameters such as ph, furnace temperature (t), acid ratio,time of activation that affect on the qualities prepared activated carbon produced and its efficiencywere investigated. in addition, the adsorption of congo red onto the activated olive stone carbonactive was...
full textRemoval of Hexavalent Chromium Ions from Aqueous Solution by Adsorption Using Activated Carbon Prepared from Cucumis Melo Peel Activated carbon
Activated carbon prepared from Cucumis Melo Peel was used as adsorbent for the removal of chromium ion from aqueous solution. Adsorption experiments were performed by varying initial metal ion concentration, temperature, and pH. Freundlich and Langmuir isotherms were used to analyze the equilibrium data obtained at different adsorption conditions. Adsorption results obtained, shows that the Cr ...
full textProduction of Activated Carbon from Cellulose Wastes
Cellulose wastes of a wood and paper factory were used to produce activated carbon. Several chemical agents under various conditions were used for production of activated carbon and hence their adsorption properties have been evaluated. In addition the effect of process parameters such as raw material, chemical agent concentration, impregnation ratio, carbonization temperature, carbonization ti...
full textMy Resources
Journal title
volume 37 issue 6
pages 107- 123
publication date 2018-12-01
By following a journal you will be notified via email when a new issue of this journal is published.
Hosted on Doprax cloud platform doprax.com
copyright © 2015-2023