A New Sensitivity Study of Thermal Stress Distribution for a Planar Solid Oxide Fuel Cell
Authors
Abstract:
Converting chemical energy into electricity is done by an electro-chemical device known as a fuel cell. Thermal stress is caused at high operating temperature between 700 oC to 1000 oC of SOFC. Thermal stress causes gas escape, structure variability, crack initiation, crack propagation, and cease operation of the SOFC before its lifetime. The aim of this study is to present a method that predicts the initiation of cracks in an anisotropic porous planar SOFC. The temperature and stress distribution are calculated. The code uses the generated data, stress intensity factor, and the J-integral of the materials to predict the initiation of the crack inside the porous anode and cathode. The results show that the highest thermal stress occurs at the upper corners of cathode and at the lower corners of the anode. In addition, the thickness of cathode electrode on the left side is increased by 1.5 %. Finally, the crack initiation occurs on the left side between the upper and lower corners of the cathode.
similar resources
A New Numerical Study Method of Thermal Stress Distribution and Tortuosity Effectiveness in an Anode Porous Electrode for a Planar Solid Oxide Fuel Cell
A fuel cell is an electro-chemical tool capable of converting chemical energy into electricity. High operating temperature of solid oxide fuel cell, between 700oC to 1000oC, causes thermal stress. Thermal stress causes gas escape, structure variability and cease operation of the SOFC before its lifetime.The purpose of the current paper is to present a method that predicts ...
full textA two-dimensional numerical model of a planar solid oxide fuel cell
A two-dimensional CFD model of a planar solid oxide fuel cell (SOFC) has been developed.This model can predict the performance of SOFC at various operating and design conditions.The effect of Knudsen diffusion is accounted in the porous electrode (backing) and reaction zonelayers. The mathematical model solves conservation of electrons and ions and conservation ofspecies. The model is formulate...
full textThree-dimensional modeling of transport phenomena in a planar anode-supported solid oxide fuel cell
In this article three dimensional modeling of a planar solid oxide fuel cell (SOFC) was investigated. The main objective was to attain the optimized cell operation. SOFC operation simulation involves a large number of parameters, complicated equations, (mostly partial differential equations), and a sophisticated simulation technique; hence, a finite element method (FEM) multiphysics approach ...
full textA Numerical Investigation of the Thermal Stresses of a Planar Solid Oxide Fuel Cell
A typical operating temperature of a solid oxide fuel cell (SOFC) is quite high above 750 °C and affects the thermomechanical behavior of the cell. Thermal stresses may cause microstructural instability and sub-critical cracking. Therefore, a joint analysis by the computational fluid dynamics (CFD) and computational structural mechanics based on the finite element method (FEM) was carried out t...
full texta two-dimensional numerical model of a planar solid oxide fuel cell
a two-dimensional cfd model of a planar solid oxide fuel cell (sofc) has been developed.this model can predict the performance of sofc at various operating and design conditions.the effect of knudsen diffusion is accounted in the porous electrode (backing) and reaction zonelayers. the mathematical model solves conservation of electrons and ions and conservation ofspecies. the model is formulate...
full textA new approach to microstructure optimization of solid oxide fuel cell electrodes
Designing optimal microstructures for solid oxide fuel cell (SOFC) electrodes is complicated due to the multitude of electro-chemo-physical phenomena taking place simultaneously that directly affect working conditions of a SOFC electrode and its performance. In this study, a new design paradigm is presented to obtain a balance between electrochemical sites in the form of triple phase boundary (...
full textMy Resources
Journal title
volume 5 issue 4
pages 18- 26
publication date 2018-10-14
By following a journal you will be notified via email when a new issue of this journal is published.
Hosted on Doprax cloud platform doprax.com
copyright © 2015-2023