characteristics of s-jump on roughened bed stilling basin
Authors
abstract
formation of hydraulic jump is necessary for dissipation of the excess kinetic energy downstream of spillways and gates. hydraulic jump stilling basins of sudden expansion are one of the energy dissipater structures which are used where the available tail water depth is less than the required sequent depths. in the present study to further reduce the hydraulic jump sequent depths ratio, a roughened bed type of stilling basins of sudden expansion is experi-mentally investigated. four different expansion ratios of 0.33, 0.5, 0.67 and 1 were studied under wide range of flow conditions, froude numbers between 2 and 10. results of the present study show that sequent depths ratio is 16-20 percent lower and the jump efficiency can increase 20 percent in comparison to the classical jump.
similar resources
Characteristics of S-jump on Roughened Bed Stilling Basin
Formation of hydraulic jump is necessary for dissipation of the excess kinetic energy downstream of spillways and gates. Hydraulic jump stilling basins of sudden expansion are one of the energy dissipater structures which are used where the available tail water depth is less than the required sequent depths. In the present study to further reduce the hydraulic jump sequent depths ratio, a rough...
full textExperimental Investigation of the Characteristics of Hydraulic Jump in a Diverging Stilling Basin with an Adverse Slope Using Baffle Blocks
Stilling basins have been used as an energy dissipater downstream of hydraulic structures. Dimensions of the stilling basins depends on hydraulic jump characteristics. In this research diverging hydraulic jump with an adverse slope using baffle blocks and an end sill have been studied experimentally and effect of diverging angle of the walls, adverse bed slope and baffle blocks on the hydraulic...
full textForced Hydraulic Jump by One and Two Continuous Sills in a Horizontal Stilling Basin.
Forced hydraulic jump in a horizontal stilling basin with one and two continuous sills at the downstream end of an ogee standard weir was investigated. Experiments were completed on sills of five different heights which were fixed at two different distances from the toe of the weir. The main characteristics of the jump such as the sequent depth ratio, relative roller 
length, and relative en...
full textForced Hydraulic Jump by One and Two Continuous Sills in a Horizontal Stilling Basin.
Forced hydraulic jump in a horizontal stilling basin with one and two continuous sills at the downstream end of an ogee standard weir was investigated. Experiments were completed on sills of five different heights which were fixed at two different distances from the toe of the weir. The main characteristics of the jump such as the sequent depth ratio, relative roller length, and relative ener...
full textInvestigation of B-jump Negative Step in Radial Stilling Basins
Presence of steps in radial stilling basins affect positively or negatively the characteristics of the free hydraulic jumps depending upon the type of the step, the height of the step, the position of the step in the basin and the dominant flow conditions. The effects of all these factors on the characteristics of the free radial hydraulic B-jump are addressed through the present experimental i...
full textEvaluation of ANFIS and ANFIS-PSO Models for Estimating Hydraulic Jump Characteristics
In this study accuracy of the ANFIS and ANFIS-PSO models to estimate hydraulic jump characteristics including sequence depth ratio, the jump length, the roller length ratio, and relative energy loss was evaluated in stilling basin versus laboratory results. The mentioned characteristics were measured in the stilling basin with a rectangular cross-section with four different adverse slopes, four...
full textMy Resources
Save resource for easier access later
Journal title:
journal of water sciences researchISSN 2251-7405
volume 5
issue 2 2013
Hosted on Doprax cloud platform doprax.com
copyright © 2015-2023