effect of pre-existing nano sized precipitates on microstructure and mechanical property of al-0.2wt% sc highly deformed by arb process
Authors
abstract
the effect of pre-existing nano sized precipitates on the mechanisms and rate of grain refinement has been investigated during the severe plastic deformation. a binary al–0.2sc alloy, containing coherent al3sc particles, of 3.62 nm in diameter has been deformed by accumulative roll bonding up to 10 cycles. the resulting deformed structures were quantitatively analyzed using electron backscattered diffraction and transmission electron microscope techniques, and the results have been compared to those obtained from a solution treated al–0.2sc alloy, deformed up to same accumulative roll bonding cycles. the fraction of high-angle grain boundaries and grain size in all materials was increased and decreased gradually with increasing equivalent strain, respectively. however, the aged-arb alloy had relatively higher fraction of high-angle grain boundaries and smaller grain size than those of st-arb specimens at the same accumulative roll bonding cycles. it was found in an al-0.2%sc alloy that starting microstructures significantly affect the formation of ultrafine grains during severe plastic deformation. it was shown that the small al3sc precipitates are more effective on microstructural evolution during accumulative roll bonding process. existence of fine precipitates in the starting material greatly accelerated the microstructure refinement. in this regards some unique phenomena, including softening during severe plastic deformation and dissolution of pre-existing al3sc, were observed.
similar resources
Effect of Pre-existing Nano Sized Precipitates on Microstructure and Mechanical Property of Al-0.2wt% Sc Highly Deformed by ARB Process
The effect of pre-existing nano sized precipitates on the mechanisms and rate of grain refinement has been investigated during the severe plastic deformation. A binary Al–0.2Sc alloy, containing coherent Al3Sc particles, of 3.62 nm in diameter has been deformed by accumulative roll bonding up to 10 cycles. The resulting deformed structures were quantitatively analyzed using electron backscatter...
full textthe effect of keeping reflective journals by language instructors on the process of reading comprehension among iranian high school students
خواندن ودرک مطلب از مهمترین مهارتها در یادگیری زبان خارجی محسوب می شود. این تحقیق تاثیر برگه های تامل برانگیز هدایت شده را در ارتقاع مهارت خواندن ودر ک مطلب در دانش اموزان دبیرستانی ایرانی بررسی می نماید. ازمجموع ?2 دانش آموز سال چهارم دبیرستان شهید رجایی شهرستان اسلامشهر¸ پس از اجرای آزمون استاندارد ((nelson 150a تعداد 39 دانش آموز که نمرات آنها یک سطح انحراف معیار بالاتر یا پایین تر ازمعدل قر...
Mechanical and Wear Properties of Al-Nip Composites Produced by ARB Process
In this research, Al-Ni particle composite strips are formed by accumulative roll bonding (ARB) process using Al strips and Ni powder. The rule of ARB cycles and volume percentage (Vol%) of Ni powder on the microstructure, wear resistance and mechanical properties of the formed composites are investigated. According to the tensile test results, the yield stress and tensile strengths of the Al -...
full textthe effect of explicit teaching of metacognitive vocabulary learning strategies on recall and retention of idioms
چکیده ندارد.
15 صفحه اولINVESTIGATION OF TRIBOLOGICAL CHARACTERISTICS OF AL/NANO SiO2NANOCOMPOSITES PRODUCED BY ACCUMULATIVE ROLL BONDING (ARB) PROCESS
Accumulative roll-bonding process (ARB) is an important severe plastic deformation technique for production of the ultrafine grained, nanostructured and nanocomposite materials in the form of plates and sheets. In the present work, this process used for manufacturing Al/SiO 2 nanocomposites by using Aluminum 1050 alloy sheets and nano sized SiO 2 particles, at ambient temperature. After 8 cycle...
full texteffect of seed priming and irrigation regimes on yield,yield components and quality of safflowers cultivars
این مطالعه در سال 1386-87 در آزمایشگاه و مزرعه پژوهشی دانشگاه صنعتی اصفهان به منظور تعیین مناسب ترین تیمار بذری و ارزیابی اثر پرایمینگ بر روی سه رقم گلرنگ تحت سه رژیم آبیاری انجام گرفت. برخی از مطالعات اثرات سودمند پرایمینگ بذر را بر روی گیاهان مختلف بررسی کرده اند اما در حال حاضر اطلاعات کمی در مورد خصوصیات مربوط به جوانه زنی، مراحل نموی، عملکرد و خصوصیات کمی و کیفی بذور تیمار شده ژنوتیپ های م...
My Resources
Save resource for easier access later
Journal title:
journal of ultrafine grained and nanostructured materialsPublisher: university of tehran college of engineering
ISSN 2423-6845
volume 47
issue 1 2014
Hosted on Doprax cloud platform doprax.com
copyright © 2015-2023