two-curve-shaped biosensor using photonic crystal nano-ring resonators
Authors
abstract
we design a novel nano-ring resonator using two-dimensional photonic crystal (2d-phc), for bio-sensing applications. the structure of biosensor is created by two-curve-shaped ring resonator which sandwiched by two waveguides. these are configured by removing one row of air holes. the refractive index of sensing hole is changed by binding an analyte. hence, intensity of the transmission spectrum shifts to lower value. this process is utilized for determining the properties of the analyte. the quality factor is obtained about 1550 and for a unit change in the refractive index of sensing hole, the intensity of transmission spectrum reduces as 4.125 units.
similar resources
Two-curve-shaped biosensor using photonic crystal nano-ring resonators
We design a novel nano-ring resonator using two-dimensional photonic crystal (2D-PhC), for bio-sensing applications. The structure of biosensor is created by two-curve-shaped ring resonator which sandwiched by two waveguides. These are configured by removing one row of air holes. The refractive index of sensing hole is changed by binding an analyte. Hence, intensity of the transmission spectrum...
full textA New Proposal for 4-to-2 Optical Encoder Using Nonlinear Photonic Crystal Ring Resonators
In this paper, we proposed an all optical 4-to-2 encoder that has 4 input and 3 output ports. This device generates a 2 bit binary code based on which input port is active. We used nonlinear photonic crystal ring resonators along with optical power splitter for realizing the proposed encoder. In this device the switching rate and area are obtained about 333 GHz and 612µm2 respectively.
full textTunable Channel Drop Filter using Hexagonal Photonic Crystal Ring Resonators
In this paper, we have proposed a tunable two dimensional (2D) photonic crystal (PhC) channel drop filter (CDF) using ring resonators with suitable quality factor (Q) and transmission efficiency; we investigate parameters which have an effect on resonant wavelength in this CDF, such as dielectric constant of inner, coupling, adjacent and whole rods of the structure. Dropping efficiency at the r...
full textQuality Factor Enhancement of Optical Channel Drop Filters Based on Photonic Crystal Ring Resonators
In this paper, a channel drop ring resonator filter based on two dimensional photonic crystal is proposed which is suitable for all optical communication systems. The multilayer of silicon rods in the center of resonant ring enables one to adjust resonant wavelength of the ring and enhance power coupling efficiency between ring and waveguide. Refractive index and radius of multilayer rods insid...
full textNovel Design for Photonic Crystal Ring Resonators Based Optical Channel Drop Filter
Photonic crystal ring resonators (PCRRs) are traditional structures fordesigning optical channel drop filters. In this paper, Photonic crystal channel drop filter(CDFs) with a new configuration of ring resonator is presented. The structure is made ofa square lattice of silicon rods with the refractive index nsi=3. 4 which are perforated inair with refractive index nair=1. Calculations of band s...
full textAdd-Drop and Channel-Drop Optical Filters Based on Photonic Crystal Ring Resonators
Here, we propose an add-drop and a channel drop filter based on two-dimensional photonic crystal all circular ring resonators. These structures are made of a square lattice of silicon rods with the refractive index n1=3.464 surrounded by air (with refractive index n2=1). The broadest photonic band gap occurs at the filling ratio of r/a = 0.17. Two linear defect W1 waveguides couple to the ring....
full textMy Resources
Save resource for easier access later
Journal title:
journal of nanostructuresPublisher: university of kashan
ISSN 2251-7871
volume 4
issue 3 2014
Hosted on Doprax cloud platform doprax.com
copyright © 2015-2023