evaluation of visibility of foreign bodies in the maxillofacial region: comparison of computed tomography, cone beam computed tomography, ultrasound and magnetic resonance imaging

Authors

solmaz valizadeh department of radiology, school of dentistry, shahid beheshti university of medical sciences, tehran, iran; dental research center, research institute of dental sciences, shahid beheshti university of medical sciences, tehran, iran

hamidreza pouraliakbar dental research center, research institute of dental sciences, shahid beheshti university of medical sciences, tehran, iran

leila kiani rajaie cardiovascular medical and research center, iran university of medical sciences, tehran, iran

yaser safi department of radiology, school of dentistry, shahid beheshti university of medical sciences, tehran, iran

abstract

conclusions ultrasound is recommended as the first choice when fb is located within the superficial soft tissues with no bone around it. in case of penetration of fb into deeper tissues or beneath bone, ct or cbct are recommended. otherwise, considering lower dose, cbct is preferred over ct. we can use mri if the fb is not ferromagnetic. however, ct is the first choice in emergency situations because of higher sensitivity. results all fbs in the tongue and at the soft tissue-bone interface had good visibility on us (p = 1.00). also, cbct and ct had significantly different performance regarding fb detection (p < 0.001). all wooden samples in the nasal cavity were invisible on ct scans; while, only 20% of them were invisible on cbct scans. mri showed significant differences for detection of fbs in the three locations (p < 0.001). mri could not locate iron samples due to severe artifacts and only showed their presence (bad visibility) but other fbs except for wood and tooth in the nasal cavity (100% invisible) had good visibility on mri. materials and methods in this in vitro study, iron, glass, stone, wood, asphalt, and tooth samples measuring 0.1 × 0.5 × 0.5 cm were placed in the tongue muscle, soft tissue-bone interface and nasal cavity in a fresh sheep’s head and subjected to mri, us, ct and cbct. a total of 20 images were captured by each imaging system from the six materials in the afore-mentioned locations. the images were observed by an expert oral and maxillofacial radiologist and a general radiologist. to assess reliability, 20 images were randomly observed by the observers in two separate sessions. the images were classified into three groups of good visibility, bad visibility and invisible. the data were analyzed using spss version 18, wilcoxon signed rank, pearson chi square, and fisher’s exact tests. background detection of foreign bodies (fbs) is challenging. selection of a fast and affordable imaging modality to locate the fb with minimal patient radiation dose is imperative. objectives this study sought to compare four commonly used imaging modalities namely cone beam computed tomography (cbct), magnetic resonance imaging (mri), computed tomography (ct), and ultrasound (us) for detection of fbs in the head and neck region.

Upgrade to premium to download articles

Sign up to access the full text

Already have an account?login

similar resources

Evaluation of Visibility of Foreign Bodies in the Maxillofacial Region: Comparison of Computed Tomography, Cone Beam Computed Tomography, Ultrasound and Magnetic Resonance Imaging

BACKGROUND Detection of foreign bodies (FBs) is challenging. Selection of a fast and affordable imaging modality to locate the FB with minimal patient radiation dose is imperative. OBJECTIVES This study sought to compare four commonly used imaging modalities namely cone beam computed tomography (CBCT), magnetic resonance imaging (MRI), computed tomography (CT), and ultrasound (US) for detecti...

full text

detection of foreign bodies by spiral computed tomography and cone beam computed tomography in maxillofacial regions

background and aims. the imaging techniques commonly used for foreign body detection include plain radiography, xeroradiography, computed tomography (ct) scans, magnetic resonance imaging (mri) and ultrasonography. the aim of the present study was to compare cone-beam computed tomography (cbct) with conventional ct scan in determination of the exact location of a foreign body in the maxillofaci...

full text

Artifacts of Titanium, Zirconium, and Binary Titanium-Zirconium Abutments in Compute Tomography, Cone Beam Computed Tomography, and Magnetic Resonance Imaging

Aim: The aim of this in vitro study was to evaluate imaging artifacts induced by Titanium, Zirconium, Titanium-Zirconium abutments in CT, MRI and CBCT imaging modalities.Methods: A 4×8mm titanium fixture was inserted in a dry human mandible. Titanium, Zirconium and Titanium–Zirconium abutments measuring 10.5 mm in height are located on the fixture, one by one. Each abutment was scan...

full text

Detection of Foreign Bodies by Spiral Computed Tomography and Cone Beam Computed Tomography in Maxillofacial Regions

Background and aims. The imaging techniques commonly used for foreign body detection include plain radiography, xeroradiography, computed tomography (CT) scans, magnetic resonance imaging (MRI) and ultrasonography. The aim of the present study was to compare cone-beam computed tomography (CBCT) with conventional CT scan in determination of the exact location of a foreign body in the maxillofaci...

full text

Dosimetry of Critical Organs in Maxillofacial Imaging with Cone-beam Computed Tomography

Background: While the benefits of cone-beam computed tomography (CBCT) are well known in maxillofacial imaging, the use of this modality is not risk-free.Objective: The aim of this study was to evaluate the exposure doses received by patients during maxillofacial imaging with CBCT.Methods: Entrance surface dose (ESD) was measured by using thermoluminescent dosimeters (TLDs) attached to the eyes...

full text

Evaluation of neurovascular anatomical variations in maxillary anterior region in cone beam computed tomography images

Introduction: Incisive foramen in the maxilla is the oral terminus of the nasopalatine canal. This region is important in implantology, Therefore, the aim of this study was to investigate the&nbsp; neurovascular anatomical variations in the maxillary anterior region, observed on cone beam computed tomography (CBCT) images. Materials &Methods: In this cross-sectional study, maxillary CBCT ima...

full text

My Resources

Save resource for easier access later


Journal title:
iranian journal of radiology

جلد ۱۳، شماره ۴، صفحات ۰-۰

Hosted on Doprax cloud platform doprax.com

copyright © 2015-2023