load displacement behavior of concrete beam under monotonic static and low velocity impact load
Authors
abstract
experiments were carried out to observe the influence of loading type on concrete beam specimens. beam specimens made of similar concrete mixture with the same geometry were tested under three point static loading and low velocity drop weight impact loading. load – displacement behavior, absorbed energy dissipation capacity, stiffnesses, failure modes of beam specimens were obtained and discussed. a finite element (fe) model was prepared in ansys explicit str software and the results of fe analysis were compared with experimental results. the loading type and loading rate have significant influence on the maximum load, stiffness and energy dissipation capacity. numerical results obtained from ansys explicit str fe models are consistent with the experimental results.
similar resources
Load-displacement behavior of sacroiliac joints.
We measured the load-displacement behavior of both single and paired sacroiliac (SI) joints in fresh cadaver specimens obtained from eight adults between the ages of 59 and 74 years. With both ilia fixed, static test loads were applied to the center of the sacrum along and about axes parallel and normal to the superior SI endplate. Test forces up to 294 N were applied in the superior, inferior,...
full textPhysical Nonlinear Analysis of a Beam Under Moving Harmonic Load
A prismatic beam made of a behaviorally nonlinear material is analyzed under aharmonic load moving with a known velocity. The vibration equation of motion is derived usingHamilton principle and Euler-Lagrange Equation. The amplitude of vibration, circular frequency,bending moment, stress and deflection of the beam can be calculated by the presented solution.Considering the response of the beam,...
full textApplication of linear and nonlinear vibration absorbers for the nonlinear beam under moving load
Recently, a large amount of studies have been related to nonlinear systems with multi-degrees of freedom as well as continuous systems. The purpose of this paper is to optimize passive vibration absorbers in linear and nonlinear states for an Euler-Bernoulli beam with a nonlinear vibratory behavior under concentrated moving load. The goal parameter in the optimization is maximum deflection of t...
full textA low-cost contact system to assess load displacement velocity in a resistance training machine.
This study sought to determine the validity of a new system for assessing the displacement and average velocity within machine-based resistance training exercise using the Chronojump System. The new design is based on a contact bar and a simple, low-cost mechanism that detects the conductivity of electrical potentials with a precision chronograph. This system allows coaches to assess velocity t...
full textLoad displacement behavior of the human lumbo-sacral joint.
The three-dimensional load displacement behavior of nine fresh adult L5-S1 spine motion segments was studied. Static test forces up to 160 N in anterior, posterior, and lateral shear, test forces up to 320 N in compression, and test moments up to 15.7 Nm in flexion, extension, lateral bending, and torsion were used. The six displacements of the center of the inferior L5 endplate were measured 1...
full textStatic and Dynamic Measurement of Force Transducer’s Deformation under Load
− At PTB, one designed and investigated measurement setups to determine the deformation of force transducers while applying a static or dynamic force. To measure the deformation, a differential vibrometer [1] is used which is integrated in the measurement setups. Using the deformation results one is able to calculate the transducers stiffness. An evaluation of the measurement uncertainty is pre...
full textMy Resources
Save resource for easier access later
Journal title:
international journal of civil engineeringجلد ۱۲، شماره ۴، صفحات ۴۸۸-۵۰۳
Hosted on Doprax cloud platform doprax.com
copyright © 2015-2023