z- source inverter based on sample boost optimized with particle swarm optimization (pso) algorithm
Authors
abstract
in this paper optimal torque control (otc) of stand-alone variable-speed small-scale wind turbine equipped with a permanent magnet synchronous generator and a switch- mode rectifier is presented. it is shown that with otc method in standalone configuration, power coefficient could be reached to its maximum possible value, i.e. 0.48. an appropriate control algorithm based on turbine characteristic is designed to extract maximum power from the turbine within a whole range of wind speed changes. besides, energy storage devices (battery bank) are used to ensure continuous supplying loads and power quality. the ac loads are connected to the system via a single-phase inverter as domestic appliances. dynamic stability of the system is also investigated to have a complete surveillance on the system operation in the conditions of hard wind speeds and maximum loads demand. the presented control method, and the other components of the system are modeled in matlab/simulink environment. simulation results show the good performance of the presented wind system in all case studies as well as active power balance.
similar resources
Z- Source Inverter Based On Sample Boost Optimized With Particle Swarm Optimization (PSO) Algorithm
In this paper optimal torque control (OTC) of stand-alone variable-speed small-scale wind turbine equipped with a permanent magnet synchronous generator and a switch- mode rectifier is presented. It is shown that with OTC method in standalone configuration, power coefficient could be reached to its maximum possible value, i.e. 0.48. An appropriate control algorithm based on turbine characterist...
full textA New Topology for Z-Source Inverter Based on Switched-Inductor and Boost Z-Source Inverter
In this paper, a new topology for boost Z-source inverterbased on switched-inductor cell is proposed. The operating modes of the proposed inverter are analyzed and also a suitable control method to generate the trigger signals of the inverter is presented. Having a common earth between the input source and inverter and capability to generate a higher voltage gain by using lower amounts of the d...
full textBoost Converter Controller Design Based on Particle Swarm Optimization ( PSO )
This paper proposes a novel optimization technique for the closed-loop controller design of a boost type DC-DC converter based on the Particle Swarm Optimization (PSO) algorithm. The design of the closedloop control parameters is framed as an optimization task such that the PSO algorithm can identify the controller parameters. An appropriate fitness function is then derived for the required obj...
full texta new topology for z-source inverter based on switched-inductor and boost z-source inverter
in this paper, a new topology for boost z-source inverterbased on switched-inductor cell is proposed. the operating modes of the proposed inverter are analyzed and also a suitable control method to generate the trigger signals of the inverter is presented. having a common earth between the input source and inverter and capability to generate a higher voltage gain by using lower amounts of the d...
full textMy Resources
Save resource for easier access later
Journal title:
journal of electric power and energy conversion systemsجلد ۱، شماره ۲، صفحات ۴۶-۵۱
Hosted on Doprax cloud platform doprax.com
copyright © 2015-2023