Effect of environmental conditions during heating on commercial spore strip performance.

Commercial biological indicator spore strips in glassine envelopes, produced by three manufacturers, were evaluated by fraction-negative procedures after being heated at 121.0 +/- 0.05 degrees C. Only one type of spore strip met the manufacturer's specifications. The strips of one manufacturer were further evaluated by fraction-negative and survivor curve-plate count procedures after being heated under several conditions (enclosed in glassine envelopes, in trypticase soy broth plus 0.0015% bromocresol purple, in Trypticase soy broth alone in Water for Injection, directly); Trypticase soy broth plus bromocresol purple and tryptic soy agar, respectively, were used as recovery media. The heating condition affected the D-value of the spore strip. Recovery procedures also had an effect; in all cases, the D-values obtained from the survivor curve tests were larger than those obtained from fraction-negative tests carried out under the same conditions. To determine if the differences in D-values between the two evaluation procedures were caused by the recovery media, we evaluated, by both methods, one type of spore strip heated directly and in glassine envelopes, using tryptic soy agar plus bromocresol purple and Trypticase soy broth plus 1.5% agar, respectively, as the recovery media. The survivor curve results showed that for both enclosed and unenclosed spore strips, there was a marked difference between the two recovery media; however, there was no difference when fraction-negative tests were used.