Oxynitride mediated epitaxy of gallium nitride on silicon(1 1 1) substrates in a merged hydride/metal-organic vapor phase epitaxy system
نویسنده
چکیده
A technique was developed to deposit GaN on a Si(1 1 1) substrate by a four-step process in a single reactor: formation of ultra-thin oxide, conversion to an oxynitride via NH3 exposure at the onset of growth, low-temperature MOCVD of GaN, followed by HVPE of GaN. It was found that this oxynitride compliant layer served to relieve stress at the GaN/Si interface as well as protect the Si substrate from reaction with free Ga atoms present during the initial stages of growth and interfacial reactions with the adjoining GaN film. Electron microscopy revealed that an ultra-thin (less than 2 nm) oxynitride could maintain the hexagonal epitaxial relationship of the Si substrate allowing growth of single crystal GaN. It was shown experimentally that formation of a thicker oxynitride layer was detrimental to GaN epitaxy due to loss of the epitaxial relationship. In the fi t s u ©
منابع مشابه
Gallium Nitride on Silicon for Consumer & Scalable Photonics
Gallium Nitride (GaN) is a unique material system that has been heavily exploited for photonic devices thanks to ultraviolet-to-terahertz spectral tunability. However, without a cost effective approach, GaN technology is limited to laboratory demonstrations and niche applications. In this investigation, integration of GaN on Silicon (100) substrates is attempted to enable widespread application...
متن کاملEstablishing a Two Step FACELO Process in HVPE
In order to reduce the effort needed to create self-separated, freestanding gallium nitride (GaN) layers by thick growth in hydride vapor phase epitaxy (HVPE), we established a two-step facet-controlled lateral overgrowth (FACELO) process in HVPE. Just as for the metalorganic vapor phase epitaxy (MOVPE) FACELO process, the template is produced by MOVPE growth directly on sapphire. This initial ...
متن کاملCongruent Melting of GaN at High Pressures
Gallium nitride (GaN) is a very important material in optoelectronic devices for blue light-emitting diodes and lasers [1]. These devices are usually fabricated by epitaxial growth on sapphire (Al 2O3) substrates because larg e GaN single crystals are unavailable. There is a large mismatch in the lattice constants of sapphire and GaN, which causes high-density dislocations in the deposited laye...
متن کاملInGaN multiple quantum wells grown on ELO GaN templates and the optical properties characterization
Epitaxial lateral overgrowth of gallium nitride with 1 1 2̄ 2 facets was realized by metal organic chemical vapor deposition on GaN/ sapphire (0 0 0 1) substrates with SiO2 stripe mask. After wet etching of the mask, periodic multiple quantum wells (MQWs) InGaN/GaN structures were grown on the whole surface. Cross-sectional transmission electron microscopy (TEM) showed that a higher growth rate ...
متن کاملDirection Controlled Growth of Organic Single Crystals by Novel Growth Methods
The green lasers are attractive and highly useful for lot of practical applications. It is more than fifty times brighter when compared to a red laser and thus it can be seen from miles away. Due to these features, the green lasers can be used in high-tech weapons for aiming purposes. More‐ over, the green lasers are highly useful for laser televisions and medical applications. Most of the comm...
متن کامل