Approximation effects on control charts for process monitoring
نویسنده
چکیده
In Statistical quality control a very widely used measure is average run length (ARL) which may be worked out by different methods like integral equation, approximations, and Monte Carlo simulations. The ARL measure and the other related measures are of major significance in every type of production process. An omission in its computation (and hence its related measures such as extra quadratic loss (EQL)) may cause a loss. This necessitates great care in the choice of its evaluation method. This article will deal with this issue using some approximation methods and the Monte Carlo simulations. The discrepancies among the results will be examined to highlight the deficiencies of using approximation methods in quality control techniques.
منابع مشابه
An Evaluation of an Adaptive Generalized Likelihood Ratio Charts for Monitoring the Process Mean
When the objective is quick detection both small and large shifts in the process mean with normal distribution, the generalized likelihood ratio (GLR) control charts have better performance as compared to other control charts. Only the fixed parameters are used in Reynolds and Lou’s presented charts. According to the studies, using variable parameters, detect process shifts faster than fixed pa...
متن کاملMonitoring and Diagnosing Multistage Processes: A Review of Cause Selecting Control Charts
A review of the literature on cause selecting charts (CSCs) in multistage processes is given, with a concentration on developments which have occurred since 1993. Model based control charts and multiple cause selecting charts (MCSCs) are reviewed. Several articles based on normally and non-normally distributed outgoing quality characteristics are analyzed and important issues such as economic d...
متن کاملApplication of Multivariate Control Charts for Condition Based Maintenance
Condition monitoring is the foundation of a condition based maintenance (CBM). To relate the information obtained from the condition monitoring to the actual state of the system, it is usually required a stochastic model. On the other hand, considering the interactions and similarities that exist between CBM and statistical process control (SPC), the integrated models for CBM and SPC have been ...
متن کاملA DMAIC approach for process capability improvement an engine crankshaft manufacturing process
The define–measure–analyze–improve–control (DMAIC) approach is a five-strata approach, namely DMAIC. This approach is the scientific approach for reducing the deviations and improving the capability levels of the manufacturing processes. The present work elaborates on DMAIC approach applied in reducing the process variations of the stub-end-hole boring operation of the manufacture of cra...
متن کاملA Self-starting Control Chart for Simultaneous Monitoring of Mean and Variance of Simple Linear Profiles
In many processes in real practice at the start-up stages the process parameters are not known a priori and there are no initial samples or data for executing Phase I monitoring and estimating the process parameters. In addition, the practitioners are interested in using one control chart instead of two or more for monitoring location and variability of processes. In this paper, we consider a s...
متن کاملطراحی یک سیستم فازی بعنوان جایگزینی برای نمودار کنترل مشاهدات انفرادی
Shewhart charts are the main tools for statistical process control. They are used for detecting assignable causes which affect quality of process output. From them, X and MR charts are two univariate control charts for monitoring mean and variation of measurable quality characteristics. The main drawbacks of these charts are: weakness of X chart against non-normal distribution of process data,...
متن کامل