Study of the critical heat flux condition with water and R-123 during flow boiling in microtubes. Part II – Comparison of data with correlations and establishment of a new subcooled CHF correlation
نویسندگان
چکیده
This study’s objective was to better understand the CHF condition in microchannels. The effect of different operating parameters – mass flux, inlet subcooling, exit quality, heated length and diameter – were assessed in detail in Part I of the study and compared to the behavior in conventional sized channels. Part II of the study compares the water and R-123 data with existing micro/macrochannel correlations. Existing correlations for predicting CHF in large-sized channels do not seem to be applicable to microchannels. This study has provided new subcooled CHF data for low mass fluxes and the earlier available subcooled boiling CHF correlation for microchannels (based on the data available for very high mass fluxes) is not suitable to predict such data. Based on the new subcooled CHF data, a correlation to predict CHF in lowflow subcooled boiling has been developed. 2009 Elsevier Ltd. All rights reserved.
منابع مشابه
Study of the critical heat flux condition with water and R-123 during flow boiling in microtubes. Part I: Experimental results and discussion of parametric effects
Extensive experimentation was performed to obtain flow boiling critical heat flux data in single stainless steel microtubes with diameters from 0.286 to 0.700 mm over a wide range of mass fluxes, inlet subcoolings, and exit pressures for two different working fluids (water and R-123). The effect of different operating parameters – mass flux, inlet subcooling, exit quality, heated length and dia...
متن کاملExperimental Study on the Effect of Magnetic Field on Critical Heat Flux of Ferrofluid Flow Boiling in a Vertical Tube
In the present work, the critical heat flux measurements were performed for the subcooled flow boiling of pure water and magnetic nanofluids (i.e., water + 0.01 and 0.1 vol.% Fe3O4) in a vertical tube. The effect of applying an external magnetic field on the CHF variation was studied experimentally as well. The obtained results indicated that the subcooled flow boiling CHF in the vertical tub...
متن کاملThe Effect of Linear Change of Tube Diameter on Subcooled Flow Boiling and Critical Heat Flux
One of the major industry problems is the flow boiling, where reaching to the critical heat flux (CHF) condition can lead to a temperature jump and damage of the systems. In the present study, the effects of a uniform change in tube diameter on subcooled flow boiling and CHF was numerically investigated. The Euler-Euler model was used to investigate the relationship between the two liquid and v...
متن کاملExperimental measurement of heat transfer coefficient and mass of deposited CaSO4 in subcooled flow boiling condition
Fouling is a common, fundamental and costly problem in heat transfer systems, which reduces thermal efficiency of equipment, increases the energy loss and causes strong damage to the heat transfer equipment in various industries. The main causes of fouling on the heat transfer surfaces are salts with inverse temperature-solubility in the fluid which calcium sulfate is one of the most important ...
متن کاملModeling of Upward Subcooled Flow Boiling of Refrigerant-113 in a Vertical Annulus
In this paper, a modified two-fluid model has been adopted to simulate the process of upward vertical subcooled flow boiling of refrigerant R-113 in a vertical annular channel at low pressure. The modified model considers temperature dependent properties and saturation temperature variation and was validated against a number of published low-pressure subcooled boiling experiments. The results s...
متن کامل