Active-Clamping Quad-Flyback Converter
ثبت نشده
چکیده
An active-clamping quad-flyback converter is proposed to achieve zero voltage switching (ZVS) for all power switches. The secondary sides of quad-flyback converter are connected in parallel to share the load current. Thus, the transformer copper losses and the conduction losses on the output diodes are reduced. Activeclamping part including one auxiliary switch and one clamp capacitor can release the energy stored in the magnetizing and leakage inductances such that the voltage stress of main switch is clamped and main/auxiliary switches can be turned on at ZVS. In the proposed circuit, the constant switching frequency with asymmetrical PWM waveform is generated to realize the ZVS turn-on of switches at the transition interval between main and auxiliary switches. Thus, the switching losses and thermal stresses of the semiconductors are reduced. The operation principle, system analysis and design consideration of the proposed converter are discussed in detail. Finally, a prototype of the proposed converter is implemented by 200V input voltage, 48V output voltage, 480W output power and 90kHz switching frequency to verify the theoretical analysis and the effectiveness of the proposed converter.
منابع مشابه
A Novel Soft-Switching Two-Switch Flyback Converter with a Wide Operating Range and Regenerative Clamping
A novel soft-switching two-switch flyback converter is proposed in this paper. This converter is composed of two active power switches, a flyback transformer, a blocking diode, and two passive regenerative clamping circuits. The proposed converter has the advantages of a low cost circuit configuration, a simple control scheme, a high efficiency, and a wide operating range. The circuit topology,...
متن کاملAnalysis, Design and Implementation of a New Chokeless Interleaved ZVS Forward-Flyback Converter
This paper presents an interleaved active-clamping zero-voltage-switching (ZVS) forward-flyback converter without an output choke. The presented topology has two active-clamping circuits with two separated transformers. Because of the interleaved operation of the converter, the output current ripple will be reduced. The proposed converter can approximately share the total load current between t...
متن کاملPid Controller Based Closed Loop Analysis of a High Efficient Flyback Converter with an Active Clamp Technique
This paper proposes a Z-source converter based flyback converter with a new active clamp control method. With this control methodology, the energy in the leakage inductance can be fully recycled. The absorbed leakage energy transferred to the output and input side will achieve zero voltage switching for the main switch. Thus, switching loss can be reduced. A Z-source converter network is incorp...
متن کاملSingle Phase PV Microinverter based on Interleaved Flyback Inverter
In this paper, topology of a Grid connected solar microinverter is proposed. The DC power obtained from the solar panel is converted into a rectified AC signal. This conversion is realized by an Active Clamped Flyback Converter. A full-bridge inverter which switched at a high frequency converts this rectified AC into sinusoidal AC of power frequency and this also controls the power flow directi...
متن کامل