Numerical Simulation of Middle Thick Plate in the U-Shaped Bending Spring Back and the Change of Thickness
نویسندگان
چکیده
In this paper, the typical U-shaped pieces were taken as the object of study and the finite element numerical simulation software Dynaform is applied to simulate the effect of sheet metal bending. The U-shaped bending spring back and its thickness change are analyzed. The influence law of main parameters of die structure to sheet thickness change and the spring back amount are obtained by combining with the orthogonal analysis method. Finally a set of the optimal parameter combination is found, the spring back of U-shaped piece and the change of the thickness are controlled in a reasonable range.
منابع مشابه
Analytical and Numerical Investigation of Four-roll Bending
Four-roll bending process is usually used for manufacturing of seamed thick-walled and thin-walled cylinders. Due to complexity of this process, the analytical solution of plate bending in this process has not been developed completely. The existence of friction and multi-step processing makes it more difficult. Investigation of four-roll bending process using analytical and numerical methods i...
متن کاملExact 3-D Solution for Free Bending Vibration of Thick FG Plates and Homogeneous Plate Coated by a Single FG Layer on Elastic Foundations
This paper presents new exact 3-D (three-dimensional) elasticity closed-form solutions for out-of-plane free vibration of thick rectangular single layered FG (functionally graded) plates and thick rectangular homogeneous plate coated by a functionally graded layer with simply supported boundary conditions. It is assumed that the plate is on a Winkler-Pasternak elastic foundation and elasticity ...
متن کاملNumerical Simulation and Neural Network Prediction the Cold Bending Spring back for Ship Hull Plate
The accurate prediction of the spring back has great significance to the cold bending of plates. Based on the analysis of the square non pressure head CNC bending machine forming principle, the finite element model of the cold forming of the hull plate surface was established using the ANSYS/LS-DYNA finite element software. And the spring back computing research was done on the thickness of 8 m...
متن کاملBending Analysis of Thick Isotropic Plates by Using 5th Order Shear Deformation Theory
A 5th order shear deformation theory considering transverse shear deformation effect as well as transverse normal strain deformation effect is presented for static flexure analysis of simply supported isotropic plate. The assumed displacement field accounts for non-linear variation of in-plane displacements as well as transverse displacement through the plate thickness. The condition of zero ...
متن کاملNumerical and Experimental Investigations on Springback of U-bending of DP600 Steel Alloy Sheet
The most prominent feature of sheet material forming process is an elastic recovery phenomenon during unloading which leads to springback and side wall curl. Therefore evaluation of springback and side wall curl is mandatory for production of precise products. In this paper, the effects of some parameters such as friction coefficient, sheet thickness, yield strength of sheet and blank-holder fo...
متن کامل