A Method for the Determination of a Distributed Fet Noise Model Based on Matched-source Noise- Figure Measurements
نویسنده
چکیده
A new method for the determination of a distributed FET noise model is presented. It is based on the extraction of the intrinsic noise-correlation matrix of an elemental section of the device from the device’s noise figure, measured for only one source-impedance state at a number of frequency points. Experimental results up to 40 GHz are given. © 2004 Wiley Periodicals, Inc. Microwave Opt Technol Lett 41: 221–225, 2004; Published online in Wiley InterScience (www. interscience.wiley.com). DOI 10.1002/mop.20099
منابع مشابه
A W-band Simultaneously Matched Power and Noise Low Noise Amplifier Using CMOS 0.13µm
A complete procedure for the design of W-band low noise amplifier in MMIC technology is presented. The design is based on a simultaneously power and noise matched technique. For implementing the method, scalable bilateral transistor model parameters should be first extracted. The model is also used for transmission line utilized in the amplifier circuit. In the presented method, input/output ma...
متن کاملAnalysis and design of a CMOS current reused cascaded distributed amplifier with optimum noise performance
In this paper, analysis, simulation and design of a distributed amplifier (DA) with 0.13µm CMOS technology in the frequency range of 3-40 GHz is presented. Gain cell is a current reused circuit which is optimum in gain, noise figure, bandwidth and also power dissipation. To improve the noise performance in the frequency range of interest, a T-matching low pass filter LC network which is utilize...
متن کاملA Modified Noise Analysis of a Common Source ̶ Common Gate Low Noise Transconductance Amplifier for Sub-micron Technologies
This paper is based on analysis of a common source - common gate low noise transconductance amplifier (CS-CG LNTA). Conventional noise analyses equations are modified by considering to the low output impedance of the sub-micron transistors and also, parasitic gate-source capacitance. The calculated equations are more accurate than calculated equations in other works. Also, analyses show that th...
متن کاملDesign of High Gain, High Reverse Isolation and High Input Matched Narrowband LNA for GPS L1 Band Applications Using 0.18µm Technology
Design of Global Positioning System (GPS) receiver with a low noise amplifier (LNA) in the front end remains a major design requirement for the success of modern day navigation and communication system. Any LNA is expected to meet the requirements like its ability to add the least amount of noise while providing sufficient gain, perfect input and output matching, and high linearity. However, mo...
متن کاملمدل سازی پارامتر های سرعت و عرض تایر اتومبیل به منظور پیش بینی کاهش انتشار آلودگی صدای اتومبیل
Introduction: Safe driving requires the ability of the driver to receive the messages and complying with them. The most significant consequences of noise pollution are on the human auditory system. Disorders in the auditory system can have harmful side effects for human health. By reducing this kind of pollution in large cities, the quality of life, which is one of the biggest goals of the gove...
متن کامل