Effect of Cladding Parameters on the Hardness of Bimetal Plates
نویسنده
چکیده
R.Bęczkowski, Institute of Mechanical Technology, Czestochowa University of Technology, Poland Hardness is one of the components responsible for the resistance to wear. The development of new materials with hardness surface more than 65 HRC is possible with use welding technologies. High chromium cored wires belong to welding materials that are often used to cladding to protect surface. This article show the problem of determining the important parameters of cladding FCAW to obtain the most hard surface. The use of high chromium cast iron to cladding on to structural steel S235JR showed us how important is knowledge about influence the technological parameters by made this plate and how have a significant impact on the final characteristics surface. For experiment Plackett-Burman design is used.
منابع مشابه
Punch plastic deformation pipe cladding (PPDPC) as a novel tube cladding method
This study presents a new mechanical tube cladding process named punch plastic deformation pipe cladding (PPDPC) based on local deformation by pressing a punch into the inner layer of the bimetal tube. To investigate the capability of the process, stainless steel tube (as the inner layer) is bonded to a carbon steel pipe (as the outer layer) to fabricate a bimetal pipe. Shear punch tests were u...
متن کاملA new approach to predict of mechanical properties at the interface of Aluminium/Copper explosive cladding by explosive scarf welding
Abstract: The purpose of this study is to produce scarf joint through explosive welding process (EXW). The scarf weld is a process in which the final bond interface is oblique. With applying the explosive welding technique, this joint can create a metallic bond between similar or dissimilar metals. In this study, chamfered end of aluminum and copper plates were joined explosively and named scar...
متن کاملLaser clading of Inconel 625 on ASTM A575 steel
In this research, the microstructure of Inconel 625 cladded layer on ASTM A575 steel has been investigated. By examining different parameters, the optimal single-pass sample with the least amount of dilution, porosity and fusion and suitable wetting angle was determined. Then cladding process with the optimal parameter was performed. The microstructure of the cladding layer was evaluated from t...
متن کاملLaser clading of Inconel 625 on ASTM A575 steel
In this research, the microstructure of Inconel 625 cladded layer on ASTM A575 steel has been investigated. By examining different parameters, the optimal single-pass sample with the least amount of dilution, porosity and fusion and suitable wetting angle was determined. Then cladding process with the optimal parameter was performed. The microstructure of the cladding layer was evaluated from t...
متن کاملInvestigating the microstructure and hardness of 17-4PH steel and Stellite cladded by direct laser deposition process on 17-4PH steel substrate
The purpose of this research is to laser cladding of stellite6 and stainless steel 17-4PH powders on the substrate of stainless steel 17-4PH, and investigate its solidification microstructure. The results showed that the microstructure of the stellite6 cladding has a cobalt solid solution ground phase with an FCC structure and Cr7C3 and Cr23C6 carbides. Also, the values of the primary dendrit...
متن کامل