Study by laser interferometry of the resonance modes of the shear plate used in the Standards characterization of piezoceramics
نویسندگان
چکیده
Recent Finite Element Analysis (FEA) modeling of a Standard shear plate of Navy II type PZT-based ceramics was carried out based on the full matrix material characterization Material coefficients in the linear range, including all losses, were obtained by an iterative automatic method from impedance measurements at resonance. FEA modeling has shown that the shear plate used in the standard characterization of piezoceramics is dynamically clamped at resonance, which results in an underestimation of the related shear coefficients. This work aims to examine experimentally the resonance modes of such standard shear sample by the use of the laser interferometry technique to map the displacement pattern at its free surfaces.
منابع مشابه
Resonance modes in the Standard piezoceramic shear geometry: A discussion based on finite element analysis
Several authors developed methods for the complex characterization of piezoceramics from complex impedance measurements at resonance. Alemany et al. developed an automatic iterative method, applied and reported in a first publication to four modes of resonance: (1) the length extensional mode of a thickness poled rectangular bar; (2) the length extensional mode of long rods or rectangular bars,...
متن کاملMeasuring the deposited energy from a non-ionizing laser beam in water by digital holographic interferometry
Digital Holographic interferometry is a powerful and widely used optical technique for accurate measurement of variations in physical quantities such as density, refractive index, and etc. In this study, an experimental digital holographic interferometry setup was designed and used to measure the amount of energy changes induced by absorption of radiation from a non-ionizing infrared laser beam...
متن کاملMeasurement and comparison of the temperature-dependence of refractive index of water and Plexiglas phantoms by interferometry method for their use in optical calorimetry
In radiation calorimetry by using laser beams and interferometry setups, variations induced by dose absorption in phantom can be precisely measured. Dose absorption and the induced temperature change result in refractive index variation of the material. In order to be able to measure the low amount of absorbed dose in the phantom, temperature dependence of refractive index of the material must ...
متن کاملA non-standard shear resonator for the matrix characterization of piezoceramics and its validation study by finite element analysis
Standard shear samples used for piezoceramic characterization lead to underestimation of the piezoelectric shear coefficients due to its dynamical clamping at resonance. This work presents the application of Alemany et al. ́s automatic iterative method to the resonance of a non-Standard shear sample, in order to determine the related complex parameters of piezoceramics, thus including losses, fr...
متن کاملطراحی، ساخت و مشخصه یابی پله های فازی شیشه ای برای کاربرد در تداخل سنجی جابجایی فاز
In this paper, we report on the design and fabrication of a low-cost phase shifter for application in phase shifting interferometry. Phase shifting interferometry is a powerful method for surface characterization. It uses interference data recorded during a series of predetermined phase shifts to recover the induced phase by the object surface. These controlled phase shifts are typically perfor...
متن کامل