Dependency of thermal spreading resistance on convective heat transfer coefficient
نویسندگان
چکیده
This paper presents a study of the thermal spreading resistance Rth of a small heat source on a conductive substrate subject to bottomside convective cooling. This problem has been investigated for a very long time and is well covered in the literature. However, instead of using the design curves found in many papers, the results are presented as function of the heat transfer coefficient h. Doing so, a remarkable property is revealed. The thermal resistance is proportional to the logarithm of the reciprocal heat transfer coefficient, for a broad range of at least three decades ðh 1⁄4 1 1000 W=m KÞ. This behaviour can be reasonably explained using an approximate one-dimensional heat spreading model. Being dictated by a logarithmic law, the dependency of Rth on h is rather weak. This is made clearer by the temperature profiles at the substrate bottom. Decreasing h leads to a wider spreading and hence a larger surface with the coolant is utilised, which partly compensates the poorer cooling. 2008 Elsevier Ltd. All rights reserved.
منابع مشابه
Multi-boiling Heat Transfer Analysis of a Convective Straight Fin with Temperature-Dependent Thermal Properties and Internal Heat Generation
In this study, by using the finite volume method, the heat transfer in a convective straight fin with temperature-dependent thermal properties and an internal heat generation under multi-boiling heat transfer modes are analyzed. In this regard, the local heat transfer coefficient is considered to vary within a power-law function of temperature. In the present study, the coexistence of all the b...
متن کاملNumerical study on convective heat transfer for water-based alumina nanofluids
The present work is an experimental study of steady state convective heat transfer of de-ionized water with a (0.04% by volume) volume fraction of Al2O3 nanoparticles dispersed to form a nanofluid that flows through an aluminium tube.Laminar fully developed flow heat transfer coefficient of Al2O3 nanoparticles are dispersed in water in circular tube is discussed in this paper. In order to valid...
متن کاملNumerical study on convective heat transfer for water-based alumina nanofluids
The present work is an experimental study of steady state convective heat transfer of de-ionized water with a (0.04% by volume) volume fraction of Al2O3 nanoparticles dispersed to form a nanofluid that flows through an aluminium tube.Laminar fully developed flow heat transfer coefficient of Al2O3 nanoparticles are dispersed in water in circular tube is discussed in this paper. In order to valid...
متن کاملFluid Flow and Heat Transfer of Nanofluids over a Flat Plate with Conjugate Heat Transfer
The falling and settling of solid particles in gases and liquids is a natural phenomenon happens in many industrial processes. This phenomenon has altered pure forced convection to a combination of heat conduction and heat convection in a flow over a plate. In this paper, the coupling of conduction (inside the plate) and forced convection of a non-homogeneous nanofluid flow (over a flat plate) ...
متن کاملMeasurement of Local Convective Heat Transfer Coefficient of Alumina-Water Nanofluids in a Double Tube Heat Exchanger
Heat transfer coefficient and thermal efficiency of γ-Al2O3/water nanofluids flowing through a double tube heat exchanger were experimentally investigated. The nanoparticles were well dispersed in distilled water at 0.05–0.15 %vol. A large number of experiments were performed at different fluid flow rates under turbulent flow regime (18,000<Re<40,000) and various nanofluid...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید
ثبت ناماگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید
ورودعنوان ژورنال:
- Microelectronics Reliability
دوره 48 شماره
صفحات -
تاریخ انتشار 2008