Design of a Three-Stage High-Bandwidth CMOS Transimpedance Amplifier
نویسندگان
چکیده
This report describes the development of a transimpedance amplifier that takes current as input and gives voltage as output. The amplifier consists of three CMOS amplifier stages in a fed-back configuration, achieving a transimpedance gain over 3 kΩ and a 3-dB bandwidth greater than 2.8 GHz. The amplifier operates with a 1.5 V supply voltage and a power budget of 30 mW.
منابع مشابه
A Study on Transimpedance Amplifier in 0.35 μm CMOS Technology
This paper presents a design of the transimpedance amplifier using 0.35μm CMOS technology. In the proposed transimpedance amplifier, feedback resistor RF of conventional transimpedance amplifier has been replaced by NMOS transistor as an active feedback resistor. This circuit operates at 3.3V power supply voltage and for a photocurrent of 0.5μA.The proposed transimpedance amplifier having low n...
متن کاملAnalysis and Design of High Gain, and Low Power CMOS Distributed Amplifier Utilizing a Novel Gain-cell Based on Combining Inductively Peaking and Regulated Cascode Concepts
In this study an ultra-broad band, low-power, and high-gain CMOS Distributed Amplifier (CMOS-DA) utilizing a new gain-cell based on the inductively peaking cascaded structure is presented. It is created bycascading of inductively coupled common-source (CS) stage and Regulated Cascode Configuration (RGC).The proposed three-stage DA is simulated in 0.13 μm CMOS process. It achieves flat and high ...
متن کاملAnalog Front End Low Noise Amplifier in 0.18-μm CMOS for Ultrasound Imaging Applications
We present the design of Analog front end (AFE) low noise pre-amplifier implemented in a high voltage 0.18-μm CMOS technology for a three dimensional ultrasound bio microscope (3D UBM) application. The fabricated chip has 4X16 pre-amplifiers implemented to interface a 2-D array of high frequency capacitive micro-machined ultrasound transducers (CMUT). Core AFE cell consists of a high-voltage pu...
متن کاملA 500-MHz and 60-dB Omega CMOS Transimpedance Amplifier Using the New Feedforward Stabilization Technique
This paper describes a method of extending the signal frequency bandwidth while increasing the stability of a CMOS transimpedance amplifier (TIA). The TIA consists of three inverting amplifiers in a series, and a high-pass filter plus a non-inverting amplifier that are connected to the last two inverting amplifiers stated above in parallel. The TIA is fabricated using a 0.35 μm CMOS process and...
متن کاملComparative Analysis of Transimpedance Amplifier of 45 nm and 180nm CMOS Technology
This paper gives a comparative analysis of an inductorless Complementary Metal Oxide Semiconductor (CMOS) Single-ended current-mode Transimpedance Amplifier (TIA) intended for use in front-end Optical communication for wideband operation. This technique uses N similar TIAs in parallel configuration to boost the overall bandwidth as well as the transimpedance gain which is not possible with volt...
متن کامل