Finite element method analysis of surface roughness transfer in micro flexible rolling
نویسندگان
چکیده
Micro flexible rolling aims to fabricate submillimeter thick strips with varying thickness profile, where the surface quality of products is mainly determined by initial workpiece surface roughness and subsequent surface asperity flattening process, which is affected by process parameters during rolling. This paper shows a 3D finite element model for flexible rolling of a 250 μm thick workpiece with reduction of 20 to 50%, and rolling phase with thinner thickness indicates a better ability to decrease the surface roughness. Four types of initial workpiece surface roughness are studied in the simulation, and the influences of process parameters, such as friction coefficient, rolling speed and roll gap adjusting speed, on surface asperity flattening of workpieces with different initial surface roughness have been numerically investigated and analysed.
منابع مشابه
Development of a Predictive Finite Element Model For Investigation of Phases Behavior After Cold Rolling Process
One of the surface defects that arise in sheet metal working is when the part removes from the die. Since there are no external forces to make this defect, the origin of such fail is known as residual stress. Residual stress can develop in sheet metal forming due to non uniform deformation. In this paper, the workpiece is carbon steel with different volume fractions and arrangement of ferrite ...
متن کاملBoundary Layers and Heat Transfer on a Rotating Rough Disk
The study of flow and heat transfer over rotating circular disks is of great practical importance in understanding the cooling of rotatory machinery such as turbines, electric motors and design and manufacturing of computer disk drives. This paper presents an analysis of the flow and heat transfer over a heated infinite permeable rough disk. Boundary-layer approximation reduces the elliptic Nav...
متن کاملFinite Element Analysis for Estimating the Effect of Various Working Conditions on the Temperature Gradients Created Inside a Rolling Tire
Periodic deformation of a tire during its rolling motion causes energy dissipating and heat generation due to hysteretic nature of the rubber. The increase in tire temperature may have disastrous effects on safe service life and safety of vehicles. In this study a numerical simulation based on finite element method is used for evaluating the effect of various working conditions on temperature f...
متن کاملExperiments and finite element simulations on micro-milling of Ti–6Al–4V alloy with uncoated and cBN coated micro-tools
This paperpresentsexperimental investigationsandfinite element simulationsonmicro-millingofTi–6Al– 4V alloy with fine grain uncoated and cBN coated micro-end mills. Micro-milling of Ti–6Al–4V using uncoated and cBN coated tungsten carbide micro-end mills are conducted; surface roughness, burr formation and tool wear are measured. Effects of machining parameters on surface roughness, burr format...
متن کامل