A case of bilateral revision total knee arthroplasty using distal femoral allograft–prosthesis composite and femoral head allografting at the tibial site with a varus-valgus constrained prosthesis: ten-year follow up
نویسندگان
چکیده
BACKGROUND We report the successful use of allograft-prosthesis composite (APC) and structural femoral head allografting in the bilateral reconstruction of large femoral and tibial uncontained defects during revision total knee arthroplasty (RTKA). CASE PRESENTATION A 67-year-old female with degenerative arthritis underwent bilateral total knee arthroplasty (TKA) using the Press Fit Condylar (PFC) modular knee system at our clinic in March, 1996. At 8 years postoperatively, the patient presented with painful, bilateral varus knees, with swelling, limited passive range of motion (ROM), and severe instability. We treated to reconstruct both knee using a femoral head allograft at the tibial site, a structural distal femoral allograft at the femoral site, and a varus-valgus constrained (VVC) prosthesis with cement. At the 10-year follow up, we found no infection, graft failure, loosening of implants, in spite of using massive bilateral structural femoral head allografts in RTKA. CONCLUSION The use of APC enabled a stable and durable reconstruction in this uncommon presentation with large femoral bone deficiencies encountered during a RTKA.
منابع مشابه
Reconstruction of severe uncontained bone defects in revision total knee arthroplasty in a patient with rheumatoid arthritis.
We report on a 54-year-old rheumatoid arthritic female patient with uncontained type-III tibial and femoral bone defects at the time of revision total knee arthroplasty (TKA). The knee was reconstructed using a structural distal femoral allograft and a stemmed, semi-constrained knee prosthesis. We achieved the re-alignment of a severe preoperative valgus deformity of 40 degrees. Due to postoper...
متن کاملDifferent References for Valgus Cut Angle in Total Knee Arthroplasty
Background: The valgus cut angle (VCA) of the distal femur in Total Knee Arthroplasty (TKA) is measured preoperativelyon three-joint alignment radiographs. The anatomical axis of the femur can be described as the anatomical axis of thefull length of the femur or as the anatomical axis of the distal half of the femur, which may result in different anglesin some cases. During TKA, the anatomical ...
متن کاملThe Clinical Outcome of Simultaneous Lateral Closed- Wedge Distal Femoral Osteotomy and Anterior Cruciate Ligament Reconstruction in the ACL-deficient Knees with Symptomatic Femoral Varus Deformity
Background: Nowadays combined high tibial osteotomy and ACL reconstruction is accepted as a safe and effectivesurgery for patients with symptomatic varus osteoarthritis and anterior knee instability; however, the source of varusdeformity is sometimes the femoral bone. No studies have reported concomitant ACL reconstruction and distal femoralosteotomy in ACL-deficient knees wit...
متن کاملSingle Cut Distal Femoral Varus Osteotomy (SCFO): A Preliminary Study
Background: Genu valgum usually originates from a deformity of distal femur that is often corrected by distal femoralvarus osteotomy. The osteotomy includes both components of angulationcorrection and translation because the siteof osteotomy is not commonly at the apex of deformity. Improvement of patellar tracking not only depends on valguscorrection, but also it may be partially due to centra...
متن کاملRadiologic Assessment of Distal Femur Cutting Angle in Varus Knee Candidates for Total Knee Arthroplasty
Background: In a total knee arthroplasty surgery the goal is to produce 90 degree angle between the knee articular lobe and the mechanical femoral line. Most orthopedic surgeons usually utilize a 5 to 7 degree for distal femoral cutting angle. In this study we will aim at clearing this question, that whether the” five-seven degree” distal femoral cutting angle supposed to be an equable spectrum...
متن کامل