High-field properties of carbon-doped MgB2 thin films by hybrid physical– chemical vapor deposition using different carbon sources

نویسندگان

  • Wenqing Dai
  • V Ferrando
  • A V Pogrebnyakov
  • R H T Wilke
  • Ke Chen
  • Xiaojun Weng
  • Joan Redwing
  • Chung Wung Bark
  • Chang-Beom Eom
  • Y Zhu
  • P M Voyles
  • Dwight Rickel
  • J B Betts
  • C H Mielke
  • A Gurevich
  • D C Larbalestier
  • Qi Li
چکیده

We have studied the high-field properties of carbon-doped MgB2 thin films prepared by hybrid physical–chemical vapor deposition (HPCVD). Carbon doping was accomplished by adding carbon-containing gas, such as bis(methylcyclopentadienyl)magnesium and trimethylboron, into the hydrogen carrier gas during the deposition. In both cases, Tc drops slowly and residual resistivity increases considerably with carbon doping. Both the a and c lattice constants increase with carbon content in the films, a behavior different from that of bulk carbon-doped MgB2 samples. The films heavily doped with trimethylboron show very high parallel Hc2 over 70 T at low temperatures and a large temperature derivative −dH ‖ c2/dT near Tc. These behaviors are found to depend on the unique microstructure of the films, which consists of MgB2 layers a few-nanometers thick separated by non-superconducting MgB2C2 layers. This leads to an increase in the parallel Hc2 by the geometrical effect, which is in addition to the significant enhancement of Hc2 due to changes in the scattering rates within and between the two bands present in films doped using both carbon sources. The high Hc2 and high-field Jc(H ) values observed in this work are very promising for the application of MgB2 in high magnetic fields. (Some figures may appear in colour only in the online journal)

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Optimized Conditions for Catalytic Chemical Vapor Deposition of Vertically Aligned Carbon Nanotubes

Here, we have synthesized vertically aligned carbon nanotubes (VA-CNTs), using chemical vapor deposition (CVD) method. Cobalt and ethanol are used as the catalyst and the carbon source, respectively. The effects of ethanol flow rate, thickness of Co catalyst film, and growth time on the properties of the carbon nanotube growth are investigated. The results show that the flow rate of ethanol and...

متن کامل

Gas Permeation, Mechanical Behavior and Cytocompatibility of Ultrathin Pure and Doped Diamond-Like Carbon and Silicon Oxide Films

Protective ultra-thin barrier films gather increasing economic interest for controlling permeation and diffusion from the biological surrounding in implanted sensor and electronic devices in future medicine. Thus, the aim of this work was a benchmarking OPEN ACCESS Coatings 2013, 3 269 of the mechanical oxygen permeation barrier, cytocompatibility, and microbiological properties of inorganic ~2...

متن کامل

Synthesis of carbon nano structures on Fe/Cu/AI and Al/Steel by thermal chemical vapour deposition method

Using C2H2, 112 and As gases at 550'C, carbon nanotubes were fabricated on the surfaces of twosubstrates coated by nano thin layers of metal catalysts by DC magnetron sputtering. AYStamless steel andFe/CteAl, by thermal chemical vapor deposition (TCVD) The surface properties of the substrates wereparticularly investigated, and the effect of treatment of the substrates on the CNT's growth is cri...

متن کامل

Study of MgB2 ultra-thin films in submicron size bridges

We discuss a custom built hybrid physical chemical vapour deposition (HPCVD) system for MgB2 ultra-thin film deposition: construction, deposition process development, and optimization. Achieved films on SiC substrates have a critical temperature (Tc) ranging from 35K (10nm thick films) to 41K (40nm thick films). The 20nm thick unpatterned film had a room temperature resistivity of 13μΩ·cm, wher...

متن کامل

Growth of carbon nanostructures upon stainless steel and brass by thermal chemical vapor deposition method

The lack of complete understanding of the substrate effects on carbon nanotubes (CNTs) growth poses a lot oftechnical challenges. Here, we report the direct growth of nanostructures such as the CNTs on stainless steel 304and brass substrates using thermal chemical vapor deposition (TCVD) process with C2H2 gas as carbon sourceand hydrogen as supporting gas mixed in Ar gas flow. We used an especi...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

عنوان ژورنال:

دوره   شماره 

صفحات  -

تاریخ انتشار 2011