Alternative modeling methods for plasma-based Rf ion sources.

نویسندگان

  • Seth A Veitzer
  • Madhusudhan Kundrapu
  • Peter H Stoltz
  • Kristian R C Beckwith
چکیده

Rf-driven ion sources for accelerators and many industrial applications benefit from detailed numerical modeling and simulation of plasma characteristics. For instance, modeling of the Spallation Neutron Source (SNS) internal antenna H(-) source has indicated that a large plasma velocity is induced near bends in the antenna where structural failures are often observed. This could lead to improved designs and ion source performance based on simulation and modeling. However, there are significant separations of time and spatial scales inherent to Rf-driven plasma ion sources, which makes it difficult to model ion sources with explicit, kinetic Particle-In-Cell (PIC) simulation codes. In particular, if both electron and ion motions are to be explicitly modeled, then the simulation time step must be very small, and total simulation times must be large enough to capture the evolution of the plasma ions, as well as extending over many Rf periods. Additional physics processes such as plasma chemistry and surface effects such as secondary electron emission increase the computational requirements in such a way that even fully parallel explicit PIC models cannot be used. One alternative method is to develop fluid-based codes coupled with electromagnetics in order to model ion sources. Time-domain fluid models can simulate plasma evolution, plasma chemistry, and surface physics models with reasonable computational resources by not explicitly resolving electron motions, which thereby leads to an increase in the time step. This is achieved by solving fluid motions coupled with electromagnetics using reduced-physics models, such as single-temperature magnetohydrodynamics (MHD), extended, gas dynamic, and Hall MHD, and two-fluid MHD models. We show recent results on modeling the internal antenna H(-) ion source for the SNS at Oak Ridge National Laboratory using the fluid plasma modeling code USim. We compare demonstrate plasma temperature equilibration in two-temperature MHD models for the SNS source and present simulation results demonstrating plasma evolution over many Rf periods for different plasma temperatures. We perform the calculations in parallel, on unstructured meshes, using finite-volume solvers in order to obtain results in reasonable time.

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Rf Plasma-based Ion Source Modeling on Unstructured Meshes

Ion source performance for accelerators and industrial applications can be improved through detailed numerical modeling and simulation. There are a number of technical complexities with developing robust models, including a natural separation of important time scales (rf, electron and ion motion), inclusion of plasma chemistry, and surface effects such as secondary electron emission and sputter...

متن کامل

Waveguide Assembly and Circular Polarizer for 2450 MHz ECR Ion Sources

Proper coupling of the rf power to the plasma in an electron-cyclotron resonance (ECR) ion source is probably the most important factor in achieving satisfactory performance of overdense plasmas in high-current ECR sources. Poor coupler design can lead to a variety of undesirable effects such as high reflected power, low plasma density, unstable operation, and poor performance. Scientific Solut...

متن کامل

“Electrodeless” Plasma Cathode for Neutralization of Ion Thrusters

Significant progress has been made in the characterization of the necessary parameters required to create an effective Radio Frequency (RF) plasma based electron source. Such a device has the promise of comparable current densities to and longer operational lifetimes than hollow cathodes. The operational lifetime of hollow cathodes is ultimately limited by cathode deterioration. RF sources prov...

متن کامل

Physics-electrical hybrid model for real time impedance matching and remote plasma characterization in RF plasma sources.

Plasma characterization and impedance matching are an integral part of any radio frequency (RF) based plasma source. In long pulse operation, particularly in high power operation where plasma load may vary due to different reasons (e.g. pressure and power), online tuning of impedance matching circuit and remote plasma density estimation are very useful. In some cases, due to remote interfaces, ...

متن کامل

Design and parametric study of a radio-frequency cathode

Hollow cathodes have been commonly used as the electron source and neutralizer for ion thrusters and other electric propulsion devices (like Hall thrusters)till 1960s. They provide high electron current density by using low electric power and gas. However, they have some disadvantages: Hollow cathode’s lifetime is limited by the erosion and evaporation of the insert. Additionally, impurities in...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

عنوان ژورنال:
  • The Review of scientific instruments

دوره 87 2  شماره 

صفحات  -

تاریخ انتشار 2016