Effect of strain rate and temperature on mechanical properties and fracture mode of high strength precipitation hardened ferritic steels
نویسندگان
چکیده
The effect of strain rate on the flow stress of a low carbon high strength ferritic steel that contains nanometer size Cu–Ni–Al precipitates is found to be much less than that of HSLA 65 that does not have such precipitates. This result is in agreement with the theory that such precipitates locally lower the Peierls stress for screw dislocations in body-centered cubic iron. The fracture mode in the steel is ductile over the wide ranges of strain rate and temperature investigated. 2006 Acta Materialia Inc. Published by Elsevier Ltd. All rights reserved.
منابع مشابه
Prediction of Mechanical Properties of TWIP Steels using Artificial Neural Network Modeling
In recent years, great attention has been paid to the development of high manganese austenitic TWIP steels exhibiting high tensile strength and exceptional total elongation. Due to low stacking fault energy (SFE), cross slip becomes more difficult in these steels and mechanical twinning is then the favored deformation mode besides dislocation gliding. Chemical composition along with processing ...
متن کاملThe Effect of Ferrite Grain Size on the Fatigue Behavior of Ferrite-martensite Dual-phase Steels
The effect of ferrite grain size on the fatigue and tensile properties of dual phase steels with a 0.25 volume fraction of martensite (Vm) under different heat treatments was investigated. The heat treatments were homogenized at 1200 oC along with several subsequent normalizations at 910 oC, resulting in different microstructures and mechanical properties. After heat treatment, the obtained ste...
متن کاملEnhancement of mechanical properties of low carbon steel based on heat treatment and thermo-mechanical processing routes
Thermal treatments and thermo-mechanical processing routes were applied on a conventional structural steel (st37 steel: 0.12C-1.11Mn-0.16Si) for improvement of tensile properties and enhancement of work-hardening behavior. Full annealing resulted in a sheet with coarse ferrite grains and pearlite colonies arranged alternatively in distinct bands, which showed high ductility, low strength, and t...
متن کاملMechanical Behavior of TWIP Steel in High Strain Rate Torsional Test
Advanced high strength steels (AHSS) have recently attracted great attention because of their superior mechanical properties. A modern group of these steels, known as twinning induced plasticity (TWIP) steels, shows a unique combination of strength and ductility even at high rates of strain. In order to examine the functionality of such steels in dynamic loading conditions, their mechanical beh...
متن کاملImprovement of Mechanical Properties and Work-Hardening Behavior of Intercritically Annealed Dual Phase Steel
The effect of the initial microstructure and intercritical annealing on mechanical properties and work-hardening response of a high-formability low carbon steel were studied. The work-hardening analysis was based on the modified Crussard–Jaoul method. The ferritic-pearlitic sheets showed low strength and high total elongation with the appearance of the yield point phenomenon. The occurrence of ...
متن کامل